Jump to main content
Jump to site search


Interfacial Analysis of PEM Electrolyzer Using X-ray Computed Tomography

Abstract

Polymer electrolyte membrane (PEM) electrolyzers are electrochemical energy-conversion devices that convert electricity into hydrogen fuel at high efficiencies. The interface between the porous transport layer (PTL) and catalyst layer is of interest from a transport perspective, as this interface is rough, reducing contact between the layers. Electrons, protons, water and oxygen have to simultaneously meet at this interface and there is a need to understand the optimal morphology. In this study we use operando X-ray computed tomography (CT) and X-ray radiography to visualize operation of PEM electrolyzers under two current densities: 500 and 800 mA/cm2. First, we compare performance of catalyst-coated membranes (CCM) electrolyzers with porous transport electrode (PTE) electrolyzers by correlating polarization curves to interface morphology observed with X-ray CT. At 1 A/cm2, the micro-CT CCM electrolyzer showed 200 mV improvement in potential primarily due to better contact between the electrocatalyst, membrane, and PTL. From the nano-CT imaging we discovered non-homogeneous distribution of IrOx electrocatalyst. The modeling study shows that the primary reason for performance loss in PTE configuration is due to low connectivity of catalyst particles with membrane. This causes bottlenecks in proton transport and results in high ionic potential losses in the anode. Then, we compared the polarization behavior and morphology of cells with CCMs but two types of PTLs. One was made with sintered titanium and the other with titanium fiber. The Ti fiber PTL showed higher porosity and lower tortuosities, however these better morphological properties did not necessarily translate into significantly lower potentials (45 mV difference), as the electrolyzer was not operated above 1 A/cm2. This was also confirmed by radiography study, where oxygen residence time in the channels showed similar fractions for both types of the PTLs.

Back to tab navigation

Supplementary files

Publication details

The article was received on 10 Jun 2019, accepted on 02 Dec 2019 and first published on 02 Dec 2019


Article type: Paper
DOI: 10.1039/C9SE00364A
Sustainable Energy Fuels, 2019, Accepted Manuscript

  •   Request permissions

    Interfacial Analysis of PEM Electrolyzer Using X-ray Computed Tomography

    E. Leonard, A. D. Shum, N. Danilovic, C. Capuano, K. E. Ayers, L. Pant, A. Z. Weber, X. Xiao, D. Parkinson and I. V. Zenyuk, Sustainable Energy Fuels, 2019, Accepted Manuscript , DOI: 10.1039/C9SE00364A

Search articles by author

Spotlight

Advertisements