Jump to main content
Jump to site search

Issue 4, 2002
Previous Article Next Article

CO2-laser micromachining and back-end processing for rapid production of PMMA-based microfluidic systems

Author affiliations

Abstract

In this article, we focus on the enormous potential of a CO2-laser system for rapidly producing polymer microfluidic structures. The dependence was assessed of the depth and width of laser-cut channels on the laser beam power and on the number of passes of the beam along the same channel. In the experiments the laser beam power was varied between 0 and 40 W and the passes were varied in the range of 1 to 7 times. Typical channel depths were between 100 and 300 μm, while the channels were typically 250 μm wide. The narrowest produced channel was 85 μm wide. Several bonding methods for microstructured PMMA [poly(methyl methacrylate)] parts were investigated, such as solvent-assisted glueing, melting, laminating and surface activation using a plasma asher. A solvent-assisted thermal bonding method proved to be the most time-efficient one. Using laser micromachining together with bonding, a three-layer polymer microstructure with included optical fibers was fabricated within two days. The use of CO2-laser systems to produce microfluidic systems has not been published before. These systems provide a cost effective alternative to UV-laser systems and they are especially useful in microfluidic prototyping due to the very short cycle time of production.

Back to tab navigation

Article information


Submitted
02 júl. 2002
Accepted
29 ágú. 2002
First published
17 sep. 2002

Lab Chip, 2002,2, 242-246
Article type
Paper

CO2-laser micromachining and back-end processing for rapid production of PMMA-based microfluidic systems

H. Klank, J. P. Kutter and O. Geschke, Lab Chip, 2002, 2, 242 DOI: 10.1039/B206409J

To request permission to reproduce material from this article, please go to the Copyright Clearance Center request page.

If you are an author contributing to an RSC publication, you do not need to request permission provided correct acknowledgement is given.

If you are the author of this article, you do not need to request permission to reproduce figures and diagrams provided correct acknowledgement is given. If you want to reproduce the whole article in a third-party publication (excluding your thesis/dissertation for which permission is not required) please go to the Copyright Clearance Center request page.

Read more about how to correctly acknowledge RSC content.


Social activity

Search articles by author

Spotlight

Advertisements