Open Access Article
This Open Access Article is licensed under a Creative Commons Attribution 3.0 Unported Licence
Correction: Freeze-extrusion for controllable assembly of 3-dimensional ultra-fine and amorphous fibrous matrices: potential applications in sorption
Bingnan
Mu
a,
Wei
Li
a,
Helan
Xu
a,
Lan
Xu
b and
Yiqi
Yang
*acd
aDepartment of Textiles, Merchandising and Fashion Design, University of Nebraska-Lincoln, 234, HECO Building, Lincoln, NE 68583-0802, USA. E-mail: yyang2@unl.edu
bDepartment of Agronomy and Horticulture, University of Nebraska-Lincoln, Lincoln, NE 68583-0915, USA
cDepartment of Biological Systems Engineering, University of Nebraska-Lincoln, 234, HECO Building, Lincoln, NE 68583-0802, USA
dNebraska Center for Materials and Nanoscience, University of Nebraska-Lincoln, 234, HECO Building, Lincoln, NE 68583-0802, USA
First published on 8th August 2018
Abstract
Correction for ‘Freeze-extrusion for controllable assembly of 3-dimensional ultra-fine and amorphous fibrous matrices: potential applications in sorption’ by Bingnan Mu et al., J. Mater. Chem. A, 2018, 6, 10320–10330.
The unit of the abscissa in Fig. 7c was reported incorrectly as m3 g−1 in the published article. The correct unit should be cm3 g−1 as shown in the corrected figure panel below (note that the figure caption remains unchanged):
Moreover, on page 10329, the text “The porosity of matrix per unit mass increased from 91.3 m3 g−1 to 411 m3 g−1” should instead read: “The porosity of matrix per unit mass increased from 91.3 cm3 g−1 to 411 cm3 g−1”.
The Royal Society of Chemistry apologises for these errors and any consequent inconvenience to authors and readers.
| This journal is © The Royal Society of Chemistry 2018 |