Open Access Article
This Open Access Article is licensed under a Creative Commons Attribution 3.0 Unported Licence
Correction: Compressible porous hybrid monoliths: preparation via a low molecular mass gelators-based gel-emulsion approach and exceptional performances
Xiangli
Chen
,
Lingling
Liu
,
Kaiqiang
Liu
,
Qing
Miao
,
Yanchao
Lü
and
Yu
Fang
*
Key Laboratory of Applied Surface and Colloid Chemistry (Shaanxi Normal University), Ministry of Education, School of Chemistry and Chemical Engineering, Shaanxi Normal University, Xi'an 710119, P. R. China. E-mail: yfang@snnu.edu.cn; Fax: +86-29-81530787; Tel: +86-29-81530788
First published on 9th December 2015
Abstract
Correction for ‘Compressible porous hybrid monoliths: preparation via a low molecular mass gelators-based gel-emulsion approach and exceptional performances’ by Xiangli Chen et al., J. Mater. Chem. A, 2015, DOI: 10.1039/c5ta08342g.
Fig. 4 of the above manuscript omitted some data. The correct Fig. 4 is shown below.
 | ||
| Fig. 4 (a) Compressive stress–strain curves of the monoliths with four different PDMS content values of 0, 2, 5, and 10 wt%, respectively, of which the data were obtained before 50% compression strain. (b) Thickness recovery (S) of the monoliths upon unloading from a compressed state (ε = 50%). The relative thickness of the monoliths after unloading is visualized by columns. | ||
The Royal Society of Chemistry apologises for these errors and any consequent inconvenience to authors and readers.
| This journal is © The Royal Society of Chemistry 2016 |