Issue 25, 2016

Microfluidic flow-injection thermal-lens microscopy for high-throughput and sensitive analysis of sub-μL samples

Abstract

An analytical method combining microfluidic flow-injection analysis (μFIA) with thermal-lens microscopy (TLM) was developed for high-throughput and sensitive analysis of sub-μL samples. The performance of μFIA-TLM was validated for detection of hexavalent chromium [Cr(VI)] in water samples. At different sample injection volumes, detection positions, and flow rates, the influence of the reaction time and the diffusion of Cr–diphenylcarbazone (DPCO) complexes on the μFIA-TLM signal were investigated. Photodegradation of the Cr–DPCO complex was clearly observed when the absorbed photons per Cr–DPCO molecule were above 1600. After optimization of TLM with respect to rapid flows (up to 10 cm s−1), we achieved a limit of detection of 0.6 ng mL−1 for Cr(VI) in a 50 μm deep channel. The impacts of interfering ions [V(V), Mo(VI), and Fe(III)] on Cr(VI) determination were found to be small. Cr(VI) contents in real samples from a cement factory were determined and found to be in good agreement with the results of spectrophotometry. This μFIA-TLM shows advantages over its conventional counterpart, such as eliminating additional sample conditioning, reducing by over 100 times the sample consumption to sub-μL volumes, and reducing by over 10 times the time required for one sample injection to a few seconds (up to 20 samples per min). The optimized μFIA-TLM setup can be applied for fast and sensitive analysis of nonfluorescent sub-μL samples in rapidly flowing mediums.

Graphical abstract: Microfluidic flow-injection thermal-lens microscopy for high-throughput and sensitive analysis of sub-μL samples

Article information

Article type
Paper
Submitted
22 جمادى الثانية 1437
Accepted
16 شعبان 1437
First published
18 شعبان 1437

Anal. Methods, 2016,8, 5053-5060

Microfluidic flow-injection thermal-lens microscopy for high-throughput and sensitive analysis of sub-μL samples

M. Liu, S. Malovrh and M. Franko, Anal. Methods, 2016, 8, 5053 DOI: 10.1039/C6AY00932H

To request permission to reproduce material from this article, please go to the Copyright Clearance Center request page.

If you are an author contributing to an RSC publication, you do not need to request permission provided correct acknowledgement is given.

If you are the author of this article, you do not need to request permission to reproduce figures and diagrams provided correct acknowledgement is given. If you want to reproduce the whole article in a third-party publication (excluding your thesis/dissertation for which permission is not required) please go to the Copyright Clearance Center request page.

Read more about how to correctly acknowledge RSC content.

Social activity

Spotlight

Advertisements