Issue 33, 2020

New, inexpensive and simple 3D printable device for nephelometric and fluorimetric determination based on smartphone sensing

Abstract

A new, inexpensive and easy to use 3D printable device was developed for nephelometric and fluorimetric determination. Its applicability was tested for the quantification of quinine in tonic drinks and sulfate in natural water with good analytical accuracy. In this way, sulfate determination was carried out by nephelometry using a red LED, while quinine was determined using a blue LED by fluorimetry. A smartphone camera was used to take the pictures and afterwards transform them into the RGB color space using the software ImageJ by a personal computer. The linear range was 2.0–50.0 mg L−1 for sulfate with a LOD of 0.13 mg L−1, and the corresponding quantification limit (LOQ) was 0.43 mg L−1. The linear range for quinine was from 0.42 to 3.10 mg L−1. The LOD and LOQ were 0.11 mg L−1 and 0.38 mg L−1, respectively.

Graphical abstract: New, inexpensive and simple 3D printable device for nephelometric and fluorimetric determination based on smartphone sensing

Supplementary files

Article information

Article type
Paper
Submitted
02 Agd 2020
Accepted
12 Cax 2020
First published
26 Cax 2020
This article is Open Access
Creative Commons BY-NC license

RSC Adv., 2020,10, 19713-19719

New, inexpensive and simple 3D printable device for nephelometric and fluorimetric determination based on smartphone sensing

E. Vidal, A. S. Lorenzetti, M. Á. Aguirre, A. Canals and C. E. Domini, RSC Adv., 2020, 10, 19713 DOI: 10.1039/D0RA02975K

This article is licensed under a Creative Commons Attribution-NonCommercial 3.0 Unported Licence. You can use material from this article in other publications, without requesting further permission from the RSC, provided that the correct acknowledgement is given and it is not used for commercial purposes.

To request permission to reproduce material from this article in a commercial publication, please go to the Copyright Clearance Center request page.

If you are an author contributing to an RSC publication, you do not need to request permission provided correct acknowledgement is given.

If you are the author of this article, you do not need to request permission to reproduce figures and diagrams provided correct acknowledgement is given. If you want to reproduce the whole article in a third-party commercial publication (excluding your thesis/dissertation for which permission is not required) please go to the Copyright Clearance Center request page.

Read more about how to correctly acknowledge RSC content.

Social activity

Spotlight

Advertisements