Issue 5, 2017

N-annulated perylene diimide dimers: the effect of thiophene bridges on physical, electronic, optical, and photovoltaic properties

Abstract

In this work, we report on the synthesis, characterization, and photovoltaic properties of two new N-annulated PDI derivatives connected with one (M1) or two (M2) thiophene bridging units and directly compare to a twisted PDI dimer with no thiophene units (tPDI-Hex). Compounds M1 and M2 were synthesized using an optimized direct heteroarylation carbon–carbon bond forming method. A combination of optical absorption and emission spectroscopy, cyclic voltammetry, polarized optical microscopy, X-ray diffraction, and density functional theory were used to characterize all compounds. Introduction of thiophene units into the PDI dimer scaffold served to red-shift the optical absorption and lower electron affinities. A decrease in the fluorescence intensity of M1 and M2 relative to tPDI-Hex was observed and attributed to photoinduced electron transfer. Notably, both M1 and M2 exhibited less structured thin-films as evidenced by optical microscopy and thin film X-ray diffraction. Photovoltaic properties were evaluated by fabricating bulk heterojunction solar cells with the inverted architecture ITO/ZnO/BHJ/MoOx/Ag and using PTB7-Th as the donor polymer. All solar cells were made and tested in air, and only ‘as-cast’ active layers were evaluated to ensure a direct comparison amongst the three acceptors. Solar cells with PTB7-Th:tPDI-Hex gave power conversion efficiencies of ∼5% with Vocs of 0.95 V, akin to our previous results. Comparatively, solar cells with PTB7-Th:M1 and PTB7-Th:M2 active layers exhibited higher Voc values upwards of 1.05 V but only had PCE of 1.1–1.2% when cast from chloroform, which we attributed to the formation of large domain sizes. A change in casting solvent to o-xylene resulted in improved bulk heterojunction morphology by reducing domain size and a doubling of the PCE values to ∼2% was realized for devices using M1 and M2 as electron acceptors. Use of the high boiling solvent, trimethylbenzene, resulted in further improvements in PCE for M1 and M2, increasing the PCE for devices using these acceptors to ∼3%. Importantly, devices made using the new materials exhibit low energy losses in the range of 0.5–0.7 eV.

Graphical abstract: N-annulated perylene diimide dimers: the effect of thiophene bridges on physical, electronic, optical, and photovoltaic properties

Supplementary files

Article information

Article type
Paper
Submitted
31 1月 2017
Accepted
20 3月 2017
First published
21 3月 2017

Sustainable Energy Fuels, 2017,1, 1137-1147

N-annulated perylene diimide dimers: the effect of thiophene bridges on physical, electronic, optical, and photovoltaic properties

A. D. Hendsbee, S. V. Dayneko, J. A. Pells, J. R. Cann and G. C. Welch, Sustainable Energy Fuels, 2017, 1, 1137 DOI: 10.1039/C7SE00056A

To request permission to reproduce material from this article, please go to the Copyright Clearance Center request page.

If you are an author contributing to an RSC publication, you do not need to request permission provided correct acknowledgement is given.

If you are the author of this article, you do not need to request permission to reproduce figures and diagrams provided correct acknowledgement is given. If you want to reproduce the whole article in a third-party publication (excluding your thesis/dissertation for which permission is not required) please go to the Copyright Clearance Center request page.

Read more about how to correctly acknowledge RSC content.

Social activity

Spotlight

Advertisements