Issue 8, 2022

Physicochemical characterization of particulate matter in a cement production plant

Abstract

Employees working in cement production plants are exposed to airborne particulate matter (PM) which may lead to lung function impairments and airway symptoms. The PM consists of raw materials, clinker and additives which vary depending on cement blend. The aim of this work was to characterize the thoracic fraction of PM with regard to size, phase composition and mixing state. Both stationary and personal impactors were used to collect size-fractionated samples in a cement production plant in Norway. Stationary samples were measured with aerosol particle counters and collected with a 13-stage cascade impactor, which were stationed at three locations of the cement production plant: at the raw meal mill, clinker conveyor belt and cement mill. Sioutas cascade impactors, and thoracic and respirable dust samplers were used in parallel for personal sampling. Additionally, particles for electron microscopy were collected with the stationary cascade impactor for size-fractionated single particle characterization. Gravimetric measurements and element compositions of the samples from the stationary impactors show that the PM mass is dominated by calcium-rich particles of size >1 μm. The size distribution results of stationary and personal impactors were similar. Characterization of single particles reveals that limestone is the dominating material in the raw meal mill, whereas clinker and limestone dominate at the clinker conveyor belt and at the cement mill. The element composition of clinker PM did not change with particle size. The PM collected on impactor stages with aerodynamic diameter cut-offs below 0.56 μm was dominated by soot and volatile secondary particles at the three locations. The number of ultrafine particles of the cement related compounds was low. Air concentrations of PM in personal respirable and thoracic samples ranged from 0.14–10 mg m−3 to 0.37–9.5 mg m−3, respectively. Considerable local variations exist, both in composition and air concentration of the PM.

Graphical abstract: Physicochemical characterization of particulate matter in a cement production plant

Supplementary files

Article information

Article type
Paper
Submitted
04 4月 2022
Accepted
10 6月 2022
First published
25 7月 2022
This article is Open Access
Creative Commons BY license

Environ. Sci.: Processes Impacts, 2022,24, 1243-1256

Physicochemical characterization of particulate matter in a cement production plant

T. K. Ervik, S. Eriksen Hammer, H. Notø, D. G. Ellingsen, Y. Thomassen, S. Weinbruch, N. Benker and B. Berlinger, Environ. Sci.: Processes Impacts, 2022, 24, 1243 DOI: 10.1039/D2EM00139J

This article is licensed under a Creative Commons Attribution 3.0 Unported Licence. You can use material from this article in other publications without requesting further permissions from the RSC, provided that the correct acknowledgement is given.

Read more about how to correctly acknowledge RSC content.

Social activity

Spotlight

Advertisements