Issue 39, 2021

Quality improvement mechanism of sputtered AlN films on sapphire substrates with high-miscut-angles along different directions

Abstract

Low dislocation AlN films are the key to prepare high-quality deep ultraviolet emission devices. So, how to reduce the dislocation of the films under the conditions of low cost and high efficiency has become a challenge in the film epitaxy growth. Therefore, this paper combined the magnetron sputtering and high-temperature annealing (HTA) technology, exploring thermal annealing of high-miscut-angle AlN films along different directions. High-resolution X-ray diffraction (XRD) and an optical microscope (OM) were used to characterize the film qualities. After annealing at 1400–1650 °C, the quality of sputtered AlN films improved significantly. The full width at half maximum (FWHM) of (0002) and (10–12) rocking curves decreased as the miscut angles of sapphire increased. The minimum values were obtained when the sapphire substrate had 4° miscut angles along from (0001) to the (11–20) direction. Raman spectroscopy, scanning electron microscopy (SEM), photoluminescence (PL) and X-ray photoelectron spectroscopy (XPS) further revealed the mechanism of enhancing the film quality by annealing. The essence of annealing to improve the film quality lies in the elimination of grain boundaries.

Graphical abstract: Quality improvement mechanism of sputtered AlN films on sapphire substrates with high-miscut-angles along different directions

Article information

Article type
Paper
Submitted
17 Тра 2021
Accepted
09 Лип 2021
First published
16 Сер 2021

CrystEngComm, 2021,23, 6871-6878

Quality improvement mechanism of sputtered AlN films on sapphire substrates with high-miscut-angles along different directions

Y. Yue, M. Sun, X. Li, T. Liu, Y. Lu, J. Chen, Y. Peng, M. Maraj, J. Zhang and W. Sun, CrystEngComm, 2021, 23, 6871 DOI: 10.1039/D1CE00654A

To request permission to reproduce material from this article, please go to the Copyright Clearance Center request page.

If you are an author contributing to an RSC publication, you do not need to request permission provided correct acknowledgement is given.

If you are the author of this article, you do not need to request permission to reproduce figures and diagrams provided correct acknowledgement is given. If you want to reproduce the whole article in a third-party publication (excluding your thesis/dissertation for which permission is not required) please go to the Copyright Clearance Center request page.

Read more about how to correctly acknowledge RSC content.

Social activity

Spotlight

Advertisements