Issue 8, 2016

Immobilized Grubbs catalysts on mesoporous silica materials: insight into support characteristics and their impact on catalytic activity and product selectivity

Abstract

Silica materials show a high ability to physisorb the 2nd generation Hoveyda–Grubbs catalyst (HG2) in organic solvents. The interaction with the complex, likely proceeding through hydrogen bonding, is particularly strong with surfaces rich in silanols, wherein geminal silanols show the highest affinity, and therefore mesoporous silicas are the supports of choice. As long as the silica material is sufficiently pure and free of cages, in which high HG2 concentrations can accumulate, the immobilization of HG2 occurs in a very stable manner. Despite the complex stability, exploration of HG2-loaded mesoporous silica supports in metathesis of cis-cyclooctene indicated significant diffusional and confinement effects, and therefore control of pore size, pore architecture and morphology in balance with the intrinsic catalytic activity is essential for catalyst design. As metathesis of cis-cyclooctene apparently proceeds through the initial formation of linear polymers, followed by backbiting forming cyclic oligomers, potential interference of mass transport and space restriction issues is not surprising. This study shows that the catalyst requirements are best met with the TUD-1 silica support (1.24 wt% HG2). Under such conditions, the heterogeneous catalyst performs as good as the homogeneous one, presenting a thermodynamic distribution of cyclic oligomers. The latter catalyst also showed high catalyst stability in a continuous fixed bed reactor, corresponding to a catalytic turnover number of 18 000. The catalytic rates and catalyst stability are lower when operating in a diffusional regime, therefore long reaction times are required to reach the thermodynamic product distribution. Water removal from the catalyst is also important, not because of HG2 stability reasons, but of lower reaction rates which were measured for hydrated samples, likely due to inhibition of cis-cyclooctene uptake in the pores. Mild removal of physisorbed water before immobilization is therefore advised, for instance by thermal treatments, but care has to be taken to keep the silanol density high for firm HG2 immobilization and also to avoid formation of reactive siloxanes, which chemically react with and destroy HG2. Surprisingly, reactive siloxane formation conditions strongly depend on the silica type, with TUD-1 being fairly sensitive to their formation. Finally, the best HG2-loaded TUD-1 catalyst is used successfully in a broad set of other metathesis reactions.

Graphical abstract: Immobilized Grubbs catalysts on mesoporous silica materials: insight into support characteristics and their impact on catalytic activity and product selectivity

Supplementary files

Article information

Article type
Paper
Submitted
04 Лис 2015
Accepted
03 Гру 2015
First published
07 Гру 2015

Catal. Sci. Technol., 2016,6, 2580-2597

Immobilized Grubbs catalysts on mesoporous silica materials: insight into support characteristics and their impact on catalytic activity and product selectivity

A. Dewaele, B. Van Berlo, J. Dijkmans, P. A. Jacobs and B. F. Sels, Catal. Sci. Technol., 2016, 6, 2580 DOI: 10.1039/C5CY01897H

To request permission to reproduce material from this article, please go to the Copyright Clearance Center request page.

If you are an author contributing to an RSC publication, you do not need to request permission provided correct acknowledgement is given.

If you are the author of this article, you do not need to request permission to reproduce figures and diagrams provided correct acknowledgement is given. If you want to reproduce the whole article in a third-party publication (excluding your thesis/dissertation for which permission is not required) please go to the Copyright Clearance Center request page.

Read more about how to correctly acknowledge RSC content.

Social activity

Spotlight

Advertisements