Issue 8, 2013

Determination of boron in high-temperature alloy steel using non-linear inter-element correction and microwave plasma-atomic emission spectrometry

Abstract

The determination of B in high-temperature alloy steel using microwave plasma-atomic emission spectrometry (MP-AES) is presented. This instrumental emission technique was developed recently using 2.45 GHz microwaves to generate atmospheric pressure N2-plasma, self-sustained inside a modified inductively coupled plasma (ICP) torch. The sample introduction to the MP is pneumatic using a conventional concentric nebulizer and a cyclonic spray chamber system. The emission line detection is sequential using a Czerny-Turner monochromator and charge-coupled device (CCD) system. Boron in steel, generally considered an analytically difficult element in a highly impacted matrix, was determined using HNO3–HCl digested steel solutions and 249.773 nm B emission line. Iron spectral interference on this B emission line was corrected using a non-linear inter-element correction (NL-IEC) method. Steel matrix effects on B recovery were attenuated using the method of standard addition. The amount of B in NBS 348a steel is found to be 58 ± 1 mg kg−1 and the certified amount of B is 55 ± 4 mg kg−1.

Graphical abstract: Determination of boron in high-temperature alloy steel using non-linear inter-element correction and microwave plasma-atomic emission spectrometry

Article information

Article type
Paper
Submitted
28 Mac 2013
Accepted
08 Mei 2013
First published
24 Mei 2013

J. Anal. At. Spectrom., 2013,28, 1242-1246

Determination of boron in high-temperature alloy steel using non-linear inter-element correction and microwave plasma-atomic emission spectrometry

T. D. Hettipathirana, J. Anal. At. Spectrom., 2013, 28, 1242 DOI: 10.1039/C3JA50103E

To request permission to reproduce material from this article, please go to the Copyright Clearance Center request page.

If you are an author contributing to an RSC publication, you do not need to request permission provided correct acknowledgement is given.

If you are the author of this article, you do not need to request permission to reproduce figures and diagrams provided correct acknowledgement is given. If you want to reproduce the whole article in a third-party publication (excluding your thesis/dissertation for which permission is not required) please go to the Copyright Clearance Center request page.

Read more about how to correctly acknowledge RSC content.

Social activity

Spotlight

Advertisements