Issue 5, 2023

On design of plasma jet reactor for non-oxidative methane conversion

Abstract

Non-oxidative methane coupling in an atmospheric pressure plasma jet reactor with an internal diameter of 3.0 mm has been studied. The jet reactor consisted of a quartz tube surrounded by a copper ring and a stainless-steel tube, which were separated by a variable distance. The stainless-steel tube (inner diameter: 1.0 mm, outer diameter: 1.5 mm) served as high voltage electrode and gas inlet. The jet characteristics with different tip angles of the high voltage electrode were investigated using voltage–current waveforms and gas analysis at a constant methane flow rate of 100 ml min−1. The effect of the length of the ground electrode and the gap between the electrodes on conversion, C2 selectivity and energy efficiency has been studied. The methane conversion was nearly tripled with a sharp angle of the electrode (15°), while the energy consumption was reduced from 150 to 55 kJ molC2Hy−1. The carbon deposition was also reduced.

Graphical abstract: On design of plasma jet reactor for non-oxidative methane conversion

Article information

Article type
Paper
Submitted
06 Des 2022
Accepted
17 Feb 2023
First published
21 Feb 2023
This article is Open Access
Creative Commons BY-NC license

React. Chem. Eng., 2023,8, 1125-1133

On design of plasma jet reactor for non-oxidative methane conversion

G. De Felice, S. Li, F. Gallucci, N. Pourali and E. Rebrov, React. Chem. Eng., 2023, 8, 1125 DOI: 10.1039/D2RE00536K

This article is licensed under a Creative Commons Attribution-NonCommercial 3.0 Unported Licence. You can use material from this article in other publications, without requesting further permission from the RSC, provided that the correct acknowledgement is given and it is not used for commercial purposes.

To request permission to reproduce material from this article in a commercial publication, please go to the Copyright Clearance Center request page.

If you are an author contributing to an RSC publication, you do not need to request permission provided correct acknowledgement is given.

If you are the author of this article, you do not need to request permission to reproduce figures and diagrams provided correct acknowledgement is given. If you want to reproduce the whole article in a third-party commercial publication (excluding your thesis/dissertation for which permission is not required) please go to the Copyright Clearance Center request page.

Read more about how to correctly acknowledge RSC content.

Social activity

Spotlight

Advertisements