Issue 17, 2016

Design and fabrication of a microfluidic SERS chip with integrated Ag film@nanoAu

Abstract

A “sandwich” microfluidic surface enhanced Raman scattering (SERS) chip with Ag film@nanoAu prepared in a microchannel was proposed and fabricated in situ. The integrated composite Ag film@nanoAu was prepared in situ by way of chemical plating and self-assembly. Firstly, the preparation conditions were optimized. On the basis of that, the influence of the laser focus position along the vertical direction and the materials of the cover plates on the SERS effect were investigated and optimized in detail. The optimized SERS effect was observed when the laser was focused on the interface of the sample and the SERS substrate. The SERS intensity of Rhodamine 6G (R6G) decreased 2.5 times and 2.1 times when PDMS or glass was used as the cover plate separately. Compared to single gold and silver SERS substrates, the composite of Ag film@nanoAu integrated in the microfluidic channel resulted in the peak intensity increasing 3–5 times during the SERS detection of R6G at 1507 cm−1. The enhancing effect could be attributed to the change in the local electromagnetic field which was caused by the synergistic sensitizing effect between the Au nanoparticles and the underlying silver mirror film. It was illustrated that the detection limit for R6G was 10−8 M and the enhancement factor (EF) was 3.8 × 105 with a relative standard deviation (RSD) of approximately 10% in the as-prepared microfluidic SERS chip.

Graphical abstract: Design and fabrication of a microfluidic SERS chip with integrated Ag film@nanoAu

Article information

Article type
Paper
Submitted
25 nov 2015
Accepted
18 jan 2016
First published
22 jan 2016

RSC Adv., 2016,6, 14105-14111

Design and fabrication of a microfluidic SERS chip with integrated Ag film@nanoAu

H. Zhao, Y. Xu, C. Wang, R. Wang, S. Xiang and L. Chen, RSC Adv., 2016, 6, 14105 DOI: 10.1039/C5RA25018H

To request permission to reproduce material from this article, please go to the Copyright Clearance Center request page.

If you are an author contributing to an RSC publication, you do not need to request permission provided correct acknowledgement is given.

If you are the author of this article, you do not need to request permission to reproduce figures and diagrams provided correct acknowledgement is given. If you want to reproduce the whole article in a third-party publication (excluding your thesis/dissertation for which permission is not required) please go to the Copyright Clearance Center request page.

Read more about how to correctly acknowledge RSC content.

Social activity

Spotlight

Advertisements