Issue 9, 2017

Predicting and optimising the energy yield of perovskite-on-silicon tandem solar cells under real world conditions

Abstract

Metal halide perovskite absorber materials have emerged as a potential new technology for large-scale low-cost photovoltaic solar power. One great advantage lies in the ability to tune their light absorption band across the visible to near infrared spectral regions, making it an ideal candidate for tandem solar cell applications, in combination with traditional crystalline silicon. For a multi-junction solar cell to operate at peak efficiency, the current generation in all junctions must closely match, especially for monolithically integrated tandem architectures. It is feasible to achieve such matching under a standardized solar spectrum with direct illumination. However, under real world conditions the spectrum of sun light, and the fraction of diffuse to direct sun light varies considerably depending upon the location and weather conditions. Hence, it is not directly obvious how much more efficient a multi-junction solar cell needs to be, in comparison to a single junction cell, before it will produce more electrical power under real world conditions. Here, we introduce a rigorous optical and device simulation to optimize perovskite-on-silicon tandem solar cells and identify feasibility of various optimisation parameters to achieve the highest possible efficiencies. Firstly, we determine that the ideal bandgap for a perovskite “top-cell” is 1.65 eV, which will deliver up to 32% efficiency when combined with a silicon rear cell. Furthermore, we calculate the annual energy yield under hourly spectrum changes at different locations and optimize the stack to show that tandem solar cells are yielding up to 30% more energy output than the single junction silicon. Most critically, the standardized air mass 1.5 efficiency measurement improvements observed for the tandems cells, translate almost entirely to the same fractional improvement in energy yield. Hence, the efficiency of the tandem cell is not significantly “de-rated” by real world spectral variations. We do observe however, that tandem solar cell stacks can deliver further improvements by optimising differently depending on the location of installation. Our results justify the drive towards monolithically integrated multi-junction solar cells, and will enable guidance to design the ideal perovskite tandem device and allow estimations for energy yield and hence the levelized cost of electricity.

Graphical abstract: Predicting and optimising the energy yield of perovskite-on-silicon tandem solar cells under real world conditions

Supplementary files

Article information

Article type
Paper
Submitted
06 maj 2017
Accepted
09 avg 2017
First published
09 avg 2017

Energy Environ. Sci., 2017,10, 1983-1993

Predicting and optimising the energy yield of perovskite-on-silicon tandem solar cells under real world conditions

M. T. Hörantner and H. J. Snaith, Energy Environ. Sci., 2017, 10, 1983 DOI: 10.1039/C7EE01232B

To request permission to reproduce material from this article, please go to the Copyright Clearance Center request page.

If you are an author contributing to an RSC publication, you do not need to request permission provided correct acknowledgement is given.

If you are the author of this article, you do not need to request permission to reproduce figures and diagrams provided correct acknowledgement is given. If you want to reproduce the whole article in a third-party publication (excluding your thesis/dissertation for which permission is not required) please go to the Copyright Clearance Center request page.

Read more about how to correctly acknowledge RSC content.

Social activity

Spotlight

Advertisements