Issue 19, 2022

Femtosecond laser direct writing of a 3D microcantilever on the tip of an optical fiber sensor for on-chip optofluidic sensing

Abstract

Real-time detection of the concentration of input fluid is essential for optofluidic sensing, especially in the case of biochips and organ-on-a-chip systems. In this paper, a microcantilever structure that enables temperature and liquid concentration sensing was fabricated on the tip of the optical fiber by femtosecond laser direct writing (two-photon polymerization, TPP) technology. An open Fabry–Pérot interferometer (F–P) structure was formed between the end of the optical fiber and the cantilever, so the sensor becomes quite sensitive to the localized temperature, concentration and refractive index of the target liquids. The reasonable size parameters of the cantilever were determined by structural stress analysis and interference spectrum analysis. By integrating the fiber sensor with a microfluidic chip, an on-chip optofluidic sensing platform is developed, which shows high sensitivities of the temperature (92.7 pm °C−1), concentration (0.3287 nm (g L−1)−1), and refractive index (1385.819 nm RIU−1). The reported optofluidic sensing platform demonstrates reasonably high stability and satisfactory sensing effect, holding great promise for applications in lab-on-a-chip systems.

Graphical abstract: Femtosecond laser direct writing of a 3D microcantilever on the tip of an optical fiber sensor for on-chip optofluidic sensing

Article information

Article type
Paper
Submitted
08 júl 2022
Accepted
22 aug 2022
First published
23 aug 2022

Lab Chip, 2022,22, 3734-3743

Femtosecond laser direct writing of a 3D microcantilever on the tip of an optical fiber sensor for on-chip optofluidic sensing

C. Li, Y. Liu, C. Lang, Y. Zhang and S. Qu, Lab Chip, 2022, 22, 3734 DOI: 10.1039/D2LC00625A

To request permission to reproduce material from this article, please go to the Copyright Clearance Center request page.

If you are an author contributing to an RSC publication, you do not need to request permission provided correct acknowledgement is given.

If you are the author of this article, you do not need to request permission to reproduce figures and diagrams provided correct acknowledgement is given. If you want to reproduce the whole article in a third-party publication (excluding your thesis/dissertation for which permission is not required) please go to the Copyright Clearance Center request page.

Read more about how to correctly acknowledge RSC content.

Social activity

Spotlight

Advertisements