Issue 19, 2016

Shell effects on hole-coupled electron transfer dynamics from CdSe/CdS quantum dots to methyl viologen

Abstract

Electron transfer (ET) dynamics from the 1Se electron state in quasi-type II CdSe/CdS core/shell quantum dots (QDs) to adsorbed methyl viologen (MV2+) were measured using femtosecond transient absorption spectroscopy. The intrinsic ET rate kET was determined from the measured average number of ET-active MV2+ per QD, which permits reliable comparisons of variant shell thickness and different hole states. The 1Se electron was extracted efficiently from the CdSe core, even for CdS shells up to 20 Å thick. The ET rate decayed exponentially from 1010 to 109 s−1 for increasing CdS shell thicknesses with an attenuation factor β ≈ 0.13 Å−1. We observed that compared to the ground state exciton 1Se1S3/2 the electron coupled to the 2S3/2 hot hole state exhibited slower ET rates for thin CdS shells. We attribute this behaviour to an Auger-assisted ET process (AAET), which depends on electron–hole coupling controlled by the CdS shell thickness.

Graphical abstract: Shell effects on hole-coupled electron transfer dynamics from CdSe/CdS quantum dots to methyl viologen

Supplementary files

Article information

Article type
Paper
Submitted
08 jan 2016
Accepted
25 abr 2016
First published
26 abr 2016
This article is Open Access
Creative Commons BY-NC license

Nanoscale, 2016,8, 10380-10387

Shell effects on hole-coupled electron transfer dynamics from CdSe/CdS quantum dots to methyl viologen

P. Zeng, N. Kirkwood, P. Mulvaney, K. Boldt and T. A. Smith, Nanoscale, 2016, 8, 10380 DOI: 10.1039/C6NR00168H

This article is licensed under a Creative Commons Attribution-NonCommercial 3.0 Unported Licence. You can use material from this article in other publications, without requesting further permission from the RSC, provided that the correct acknowledgement is given and it is not used for commercial purposes.

To request permission to reproduce material from this article in a commercial publication, please go to the Copyright Clearance Center request page.

If you are an author contributing to an RSC publication, you do not need to request permission provided correct acknowledgement is given.

If you are the author of this article, you do not need to request permission to reproduce figures and diagrams provided correct acknowledgement is given. If you want to reproduce the whole article in a third-party commercial publication (excluding your thesis/dissertation for which permission is not required) please go to the Copyright Clearance Center request page.

Read more about how to correctly acknowledge RSC content.

Social activity

Spotlight

Advertisements