Issue 22, 2019

Flow stabilization in wearable microfluidic sensors enables noise suppression

Abstract

Dilatometric strain sensors (DSS) that work based on detection of volume change in microfluidic channels; i) are highly sensitive to biaxial strain, ii) can be fabricated using only soft and transparent materials, and iii) are easy to integrate with smart-phones. These features are especially attractive for contact lens based intraocular pressure (IOP) sensing applications. The inherent flow stabilization of the microfluidic systems is an additional advantage suitable for filtering out rapid fluctuations. Here, we have demonstrated that the low-pass filtering in microfluidic sensors improves the signal-to-noise-ratio for ophthalmic applications. We have fabricated devices with a time constant in the range of 1–200 seconds. We have demonstrated that the device architecture and working liquid viscosity (10–866 cSt) are the two independent factors that determine the sensor time constant. We have developed an equivalent circuit model for the DSS that accurately represents the experimental results thus can be used as a computational model for design and development of microfluidic sensors. For a sensor with the time constant of 4 s, we report that microfluidic signal filtering in IOP monitoring applications can suppress the rapid fluctuations (i.e., the noise due to ocular pulsation, blinking etc.) by 9 dB without the need for electronic components.

Graphical abstract: Flow stabilization in wearable microfluidic sensors enables noise suppression

Supplementary files

Article information

Article type
Paper
Submitted
22 ago 2019
Accepted
11 out 2019
First published
15 out 2019

Lab Chip, 2019,19, 3899-3908

Flow stabilization in wearable microfluidic sensors enables noise suppression

I. E. Araci, S. Agaoglu, J. Y. Lee, L. Rivas Yepes, P. Diep, M. Martini and A. Schmidt, Lab Chip, 2019, 19, 3899 DOI: 10.1039/C9LC00842J

To request permission to reproduce material from this article, please go to the Copyright Clearance Center request page.

If you are an author contributing to an RSC publication, you do not need to request permission provided correct acknowledgement is given.

If you are the author of this article, you do not need to request permission to reproduce figures and diagrams provided correct acknowledgement is given. If you want to reproduce the whole article in a third-party publication (excluding your thesis/dissertation for which permission is not required) please go to the Copyright Clearance Center request page.

Read more about how to correctly acknowledge RSC content.

Social activity

Spotlight

Advertisements