Issue 42, 2018

Unique features of the generation–recombination noise in quasi-one-dimensional van der Waals nanoribbons

Abstract

We describe the low-frequency current fluctuations, i.e. electronic noise, in quasi-one-dimensional ZrTe3 van der Waals nanoribbons, which have recently attracted attention owing to their extraordinary high current carrying capacity. Whereas the low-frequency noise spectral density, SI/I2, reveals 1/f behavior near room temperature, it is dominated by the Lorentzian bulges of the generation–recombination noise at low temperatures (I is the current and f is the frequency). Unexpectedly, the corner frequency of the observed Lorentzian peaks shows strong sensitivity to the applied source–drain bias. This dependence on electric field can be explained by the Frenkel–Poole effect in the scenario where the voltage drop happens predominantly on the defects, which block the quasi-1D conduction channels. We also have found that the activation energy of the characteristic frequencies of the G–R noise in quasi-1D ZrTe3 is defined primarily by the temperature dependence of the capture cross-section of the defects rather than by their energy position. These results are important for the application of quasi-1D van der Waals materials in ultimately downscaled electronics.

Graphical abstract: Unique features of the generation–recombination noise in quasi-one-dimensional van der Waals nanoribbons

Supplementary files

Article information

Article type
Paper
Submitted
29 ago 2018
Accepted
08 out 2018
First published
09 out 2018

Nanoscale, 2018,10, 19749-19756

Author version available

Unique features of the generation–recombination noise in quasi-one-dimensional van der Waals nanoribbons

A. K. Geremew, S. Rumyantsev, M. A. Bloodgood, T. T. Salguero and A. A. Balandin, Nanoscale, 2018, 10, 19749 DOI: 10.1039/C8NR06984K

To request permission to reproduce material from this article, please go to the Copyright Clearance Center request page.

If you are an author contributing to an RSC publication, you do not need to request permission provided correct acknowledgement is given.

If you are the author of this article, you do not need to request permission to reproduce figures and diagrams provided correct acknowledgement is given. If you want to reproduce the whole article in a third-party publication (excluding your thesis/dissertation for which permission is not required) please go to the Copyright Clearance Center request page.

Read more about how to correctly acknowledge RSC content.

Social activity

Spotlight

Advertisements