Issue 14, 2021

Increasing the surface area and CO2 uptake of conjugated microporous polymers via a post-knitting method

Abstract

The synthesis of high-surface-area porous organic polymers (POPs) for CO2 capture and storage (CCS) has received significant attention from researchers. However, the construction of POPs with a large surface area still remains challenging in synthetic chemistry, because of the complex formation process of the porous skeletons. Herein, we developed a facile post-knitting method to increase the surface area of conjugated microporous polymers (CMPs) to improve the CO2 adsorption capacity. Four CMPs were knitted using two different cross-linkers via a Friedel–Crafts reaction to obtain eight CMP-based hyper-crosslinked polymers (KCMPs), respectively. These resulting KCMPs exhibit a high Brunauer–Emmett–Teller (BET) surface area and total pore volume up to 2267 m2 g−1 and 3.27 cm3 g−1, which are 2.3 times and 8.8 times higher than the corresponding CMPs, respectively. In addition, these KCMPs show obvious increases in the CO2 uptake with the best-performing KCMP-M4 of 3.98 mmol g−1 (89.2 cm3 g−1) at 1 bar and 273 K, an increase of 122.2% compared to the pristine CMP-4. This post-knitting method can provide more potential porous adsorbents for CCS technologies and could be used to further develop novel methods for the synthesis of high-surface-area POPs.

Graphical abstract: Increasing the surface area and CO2 uptake of conjugated microporous polymers via a post-knitting method

Supplementary files

Article information

Article type
Research Article
Submitted
08 မတ် 2021
Accepted
19 မေ 2021
First published
19 မေ 2021

Mater. Chem. Front., 2021,5, 5319-5327

Increasing the surface area and CO2 uptake of conjugated microporous polymers via a post-knitting method

Y. Liu, S. Wang, X. Meng, Y. Ye, X. Song and Z. Liang, Mater. Chem. Front., 2021, 5, 5319 DOI: 10.1039/D1QM00371B

To request permission to reproduce material from this article, please go to the Copyright Clearance Center request page.

If you are an author contributing to an RSC publication, you do not need to request permission provided correct acknowledgement is given.

If you are the author of this article, you do not need to request permission to reproduce figures and diagrams provided correct acknowledgement is given. If you want to reproduce the whole article in a third-party publication (excluding your thesis/dissertation for which permission is not required) please go to the Copyright Clearance Center request page.

Read more about how to correctly acknowledge RSC content.

Social activity

Spotlight

Advertisements