Issue 40, 2015

High performance n-type bismuth telluride based alloys for mid-temperature power generation

Abstract

Currently more than 60% of primary energy used in industry or life is lost as waste heat in the temperature range of 400–900 K, and much attention is paid to mid-temperature thermoelectric (TE) power generation. Here we combine several strategies, i.e. alloying, doping and hot deformation, to improve the TE performance of n-type bismuth telluride based TE alloys for mid-temperature power generation. Se alloying was adopted to widen the band gap and suppress intrinsic conduction at elevated temperatures. When Se atoms completely substitute the Te(2) atoms, the crystal structure of Bi2Te3 based alloys tends to be more ordered, resulting in the maximum value of the band gap. And the induced alloying scattering significantly reduces the lattice thermal conductivity. Then SbI3 donor doping was used to increase the electron concentration to further suppress the detrimental effects of bipolar conduction. Finally we applied repetitive hot deformations to further improve the figure of merit zT and a peak zT of ∼1.1 was obtained at about 600 K in the 0.1 at% SbI3–Bi2Te1.9Se1.1 alloy, which was hot-deformed three times. The results demonstrated the great potential of the alloy for application in mid-temperature TE power generation.

Graphical abstract: High performance n-type bismuth telluride based alloys for mid-temperature power generation

Supplementary files

Article information

Article type
Paper
Submitted
24 ဇူ 2015
Accepted
16 ဩ 2015
First published
18 ဩ 2015

J. Mater. Chem. C, 2015,3, 10597-10603

Author version available

High performance n-type bismuth telluride based alloys for mid-temperature power generation

Z. Tang, L. Hu, T. Zhu, X. Liu and X. Zhao, J. Mater. Chem. C, 2015, 3, 10597 DOI: 10.1039/C5TC02263K

To request permission to reproduce material from this article, please go to the Copyright Clearance Center request page.

If you are an author contributing to an RSC publication, you do not need to request permission provided correct acknowledgement is given.

If you are the author of this article, you do not need to request permission to reproduce figures and diagrams provided correct acknowledgement is given. If you want to reproduce the whole article in a third-party publication (excluding your thesis/dissertation for which permission is not required) please go to the Copyright Clearance Center request page.

Read more about how to correctly acknowledge RSC content.

Social activity

Spotlight

Advertisements