Issue 15, 2018

Discrete element simulation studies of angles of repose and shear flow of wet, flexible fibers

Abstract

A discrete element method (DEM) model is developed to simulate the dynamics of wet, flexible fibers. The angles of repose of dry and wet fibers are simulated, and the simulation results are in good agreement with experimental results, validating the wet, flexible fiber model. To study wet fiber flow behavior, the model is used to simulate shear flows of wet fibers in a periodic domain under Lees–Edwards boundary conditions. Significant agglomeration is observed in dilute shear flows of wet fibers. The size of the largest agglomerate in the flow is found to depend on a Bond number, which is proportional to liquid surface tension and inversely proportional to the square of the shear strain rate. This Bond number reflects the relative importance of the liquid-bridge force to the particle's inertial force, with a larger Bond number leading to a larger agglomerate. As the fiber aspect ratio (AR) increases, the size of the largest agglomerate increases, while the coordination number in the largest agglomerate initially decreases and then increases when the AR is greater than four. A larger agglomerate with a larger coordination number is more likely to form for more flexible fibers with a smaller bond elastic modulus due to better connectivity between the more flexible fibers. Liquid viscous force resists pulling of liquid bridges and separation of contacting fibers, and therefore it facilitates larger agglomerate formation. The effect of liquid viscous force is more significant at larger shear strain rates. The solid-phase shear stress is increased due to the presence of liquid bridges in moderately dense flows. As the solid volume fraction increases, the effect of fiber–fiber friction coefficient increases sharply. When the solid volume fraction approaches the maximum packing density, the fiber–fiber friction coefficient can be a more dominant factor than the liquid bridge force in determining the solid-phase shear stress.

Graphical abstract: Discrete element simulation studies of angles of repose and shear flow of wet, flexible fibers

Supplementary files

Article information

Article type
Paper
Submitted
29 окт. 2017
Accepted
11 мар. 2018
First published
13 мар. 2018

Soft Matter, 2018,14, 2923-2937

Discrete element simulation studies of angles of repose and shear flow of wet, flexible fibers

Y. Guo, C. Wassgren, W. Ketterhagen, B. Hancock and J. Curtis, Soft Matter, 2018, 14, 2923 DOI: 10.1039/C7SM02135F

To request permission to reproduce material from this article, please go to the Copyright Clearance Center request page.

If you are an author contributing to an RSC publication, you do not need to request permission provided correct acknowledgement is given.

If you are the author of this article, you do not need to request permission to reproduce figures and diagrams provided correct acknowledgement is given. If you want to reproduce the whole article in a third-party publication (excluding your thesis/dissertation for which permission is not required) please go to the Copyright Clearance Center request page.

Read more about how to correctly acknowledge RSC content.

Social activity

Spotlight

Advertisements