Issue 8, 2020

Aspect ratio controlled synthesis of tellurium nanowires for photovoltaic applications

Abstract

Here, we report an aspect ratio-controlled synthesis of tellurium (Te) nanowires (NWs) utilizing a hot-injection colloidal method. The synthetic method uses low cost materials – specifically, tellurium oxide (TeO2) as the tellurium source, environmentally benign ethylene glycol as a solvent, and ascorbic acid as a reducing agent. Analysis of scanning electron micrographs confirms that the NWs show narrow distributions for length, diameter, and therefore also aspect ratio. For example, we have prepared Te NWs exhibiting aspect ratios of 28.0 and 55.4. X-ray diffraction studies confirm a hexagonal crystal structure for the synthesized Te NWs. Based on Raman spectroscopy, Stokes lines were observed at 117.0 and 136.1 cm−1 for A1 and E2 modes of vibration. Fabrication of Te NW thin films demonstrated their suitability as a hole transport layer at the back contact of cadmium sulfide/cadmium telluride (CdS/CdTe) solar cells, yielding enhanced open-circuit voltage (Voc = 0.846 V) and fill factor (FF = 77.8%), and an efficiency of 14.6%; the control device has an efficiency of 13.1% (Voc = 0.825 mV, FF 74.0%).

Graphical abstract: Aspect ratio controlled synthesis of tellurium nanowires for photovoltaic applications

Article information

Article type
Paper
Submitted
09 Jūn. 2020
Accepted
10 Aug. 2020
First published
11 Aug. 2020
This article is Open Access
Creative Commons BY-NC license

Mater. Adv., 2020,1, 2721-2728

Aspect ratio controlled synthesis of tellurium nanowires for photovoltaic applications

D. Pokhrel, E. Bastola, A. B. Phillips, M. J. Heben and R. J. Ellingson, Mater. Adv., 2020, 1, 2721 DOI: 10.1039/D0MA00394H

This article is licensed under a Creative Commons Attribution-NonCommercial 3.0 Unported Licence. You can use material from this article in other publications, without requesting further permission from the RSC, provided that the correct acknowledgement is given and it is not used for commercial purposes.

To request permission to reproduce material from this article in a commercial publication, please go to the Copyright Clearance Center request page.

If you are an author contributing to an RSC publication, you do not need to request permission provided correct acknowledgement is given.

If you are the author of this article, you do not need to request permission to reproduce figures and diagrams provided correct acknowledgement is given. If you want to reproduce the whole article in a third-party commercial publication (excluding your thesis/dissertation for which permission is not required) please go to the Copyright Clearance Center request page.

Read more about how to correctly acknowledge RSC content.

Social activity

Spotlight

Advertisements