Issue 27, 2014

Preparation of layered double hydroxide/chlorophyll a hybrid nano-antennae: a key step

Abstract

In the first step to obtain an efficient nano-antenna in a bottom-up approach, new hybrid materials were synthesized using a set of layered double hydroxides (LDHs) with basic properties and pure chlorophyll a (Chl a). The stability of the adsorbed monolayer of Chl a was shown to be dependent on the nature and the ratio of the different metal ions present in the LDHs tested. The hybrid materials turned out to be adequate for stabilizing Chl a on Mg/Al LDHs for more than a month under ambient conditions while a limited catalytic decomposition was observed for the Ni/Al LDHs leading to the formation of pheophytin. These changes were followed by namely XRD, DR-UV-vis and fluorescence spectroscopies of the hybrid antennae and of the solutions obtained from their lixiviation with acetone or diethylether. On Mg/Al hydrotalcites the stability of the adsorbed Chl a was equivalent for values of the metal atom ratio ranging from 2 to 4. The latter hybrids should constitute a good basis to form efficient nanoscale light harvesting units following intercalation of selected dyes. This work describes an efficient preparation of Chl a that allows scale-up as well as the obtention of a stable Chl a monolayer on the surface of various LDHs.

Graphical abstract: Preparation of layered double hydroxide/chlorophyll a hybrid nano-antennae: a key step

Supplementary files

Article information

Article type
Paper
Submitted
13 جنؤری 2014
Accepted
27 فرؤری 2014
First published
04 مارٕچ 2014

Dalton Trans., 2014,43, 10521-10528

Author version available

Preparation of layered double hydroxide/chlorophyll a hybrid nano-antennae: a key step

A. E. Sommer Márquez, D. A. Lerner, G. Fetter, P. Bosch, D. Tichit and E. Palomares, Dalton Trans., 2014, 43, 10521 DOI: 10.1039/C4DT00113C

To request permission to reproduce material from this article, please go to the Copyright Clearance Center request page.

If you are an author contributing to an RSC publication, you do not need to request permission provided correct acknowledgement is given.

If you are the author of this article, you do not need to request permission to reproduce figures and diagrams provided correct acknowledgement is given. If you want to reproduce the whole article in a third-party publication (excluding your thesis/dissertation for which permission is not required) please go to the Copyright Clearance Center request page.

Read more about how to correctly acknowledge RSC content.

Social activity

Spotlight

Advertisements