Issue 17, 2021

In-flow electrochemical detection of chemicals in droplets with pyrolysed photoresist electrodes: application as a module for quantification of microsampled dopamine

Abstract

The electrochemical quantification of analytes in droplets of PBS separated by a fluorinated phase was investigated. PDMS-fused silica chips with pyrolysed photoresist electrodes were prepared using a simple fabrication technique and used to analyze droplets in flow. Potentiostatic chronoamperometry provided current readouts consistent with mass transport and the concentration inside the droplets. This paper highlights measurements of dopamine in droplets in T-junction microfluidic chips at unprecedently low concentrations, with a limit of detection of 207 nM and a linear range of 0.21–20 μM, giving results similar to continuous flow electrochemistry and allowing the analysis in the striatal extracellular range (<1 μM). The system was applied to the quick and reliable on-line detection of dopamine concentration steps in droplets collected with a microsampling probe in vitro, demonstrating the usefulness of the electrochemical device as a quantification module for microsampled chemicals in droplets.

Graphical abstract: In-flow electrochemical detection of chemicals in droplets with pyrolysed photoresist electrodes: application as a module for quantification of microsampled dopamine

Supplementary files

Article information

Article type
Paper
Submitted
15 Ақп. 2021
Accepted
21 Мау. 2021
First published
30 Мау. 2021

Lab Chip, 2021,21, 3328-3337

In-flow electrochemical detection of chemicals in droplets with pyrolysed photoresist electrodes: application as a module for quantification of microsampled dopamine

A. Leroy, J. Teixidor, A. Bertsch and P. Renaud, Lab Chip, 2021, 21, 3328 DOI: 10.1039/D1LC00116G

To request permission to reproduce material from this article, please go to the Copyright Clearance Center request page.

If you are an author contributing to an RSC publication, you do not need to request permission provided correct acknowledgement is given.

If you are the author of this article, you do not need to request permission to reproduce figures and diagrams provided correct acknowledgement is given. If you want to reproduce the whole article in a third-party publication (excluding your thesis/dissertation for which permission is not required) please go to the Copyright Clearance Center request page.

Read more about how to correctly acknowledge RSC content.

Social activity

Spotlight

Advertisements