Issue 38, 2013

Hot deformation induced bulk nanostructuring of unidirectionally grown p-type (Bi,Sb)2Te3 thermoelectric materials

Abstract

Nanostructuring has proved effective in improving the figure of merit in the widely used Bi2Te3 based thermoelectric materials. In this work, a hot deformation induced in situ nanostructuring process is directly applied to the commercial unidirectionally grown p-type Bi0.5Sb1.5Te3 ingots to explore the possibility of commercial application of the “top down” nanostructuring approach, and the thermoelectric properties are investigated over a wide temperature range of 15 K to 520 K. In comparison to the commercial zone melted ingot and the hot pressed sample, it is found that the hot deformed samples exhibit much less texture and significantly reduced lattice thermal conductivity due to in situ formed nanostructures and defects. A high ZT of ∼1.3 is achieved near room temperature, ∼50% improvement compared to that of the zone melted ingot. The hot deformation process thus provides a promising top down approach to prepare high performance Bi2Te3 based thermoelectric materials in a way that is more readily incorporated into the existing procedure of device manufacturing.

Graphical abstract: Hot deformation induced bulk nanostructuring of unidirectionally grown p-type (Bi,Sb)2Te3 thermoelectric materials

Article information

Article type
Paper
Submitted
17 7 2013
Accepted
01 8 2013
First published
01 8 2013

J. Mater. Chem. A, 2013,1, 11589-11594

Hot deformation induced bulk nanostructuring of unidirectionally grown p-type (Bi,Sb)2Te3 thermoelectric materials

T. Zhu, Z. Xu, J. He, J. Shen, S. Zhu, L. Hu, T. M. Tritt and X. Zhao, J. Mater. Chem. A, 2013, 1, 11589 DOI: 10.1039/C3TA12764H

To request permission to reproduce material from this article, please go to the Copyright Clearance Center request page.

If you are an author contributing to an RSC publication, you do not need to request permission provided correct acknowledgement is given.

If you are the author of this article, you do not need to request permission to reproduce figures and diagrams provided correct acknowledgement is given. If you want to reproduce the whole article in a third-party publication (excluding your thesis/dissertation for which permission is not required) please go to the Copyright Clearance Center request page.

Read more about how to correctly acknowledge RSC content.

Social activity

Spotlight

Advertisements