Issue 22, 2019

The consequences of surface heterogeneity of cobalt nanoparticles on the kinetics of CO methanation

Abstract

The CO hydrogenation reaction was studied under methanation conditions (H2/CO >3, 250–300 °C) on Co/SiO2 catalysts with different mean Co nanoparticle size (dp = 4 nm, 13 nm and 33 nm). The catalysts were prepared by incipient wetness impregnation; the cobalt loading and reduction conditions were suitably selected in order to produce catalysts with different dp. Operando FTIR and kinetic measurements provided consistent data for the heat of CO adsorption at low and full coverage. The results confirm the structural sensitivity of the CO hydrogenation reaction on supported cobalt catalysts and demonstrate the energetic heterogeneity of the cobalt surface. A model derived from the Temkin formalism accurately fits the kinetic data and renders the heterogeneity of the cobalt surface by capturing the change in the heat of CO adsorption with the CO coverage. This change is normalized by the heat of CO adsorption at high coverage (ΔQCO/Q1) in order to quantify and compare the heterogeneity of cobalt surfaces. The CO hydrogenation turnover rates are lower on the catalyst with smaller nanoparticles. This surface shows higher heterogeneity and lower apparent activation energy, which is attributed to a larger amount of the more active B5-B sites in this catalyst.

Graphical abstract: The consequences of surface heterogeneity of cobalt nanoparticles on the kinetics of CO methanation

Supplementary files

Article information

Article type
Paper
Submitted
30 ágú. 2019
Accepted
07 okt. 2019
First published
08 okt. 2019

Catal. Sci. Technol., 2019,9, 6415-6427

The consequences of surface heterogeneity of cobalt nanoparticles on the kinetics of CO methanation

J. Castillo, L. E. Arteaga-Pérez, A. Karelovic and R. Jiménez, Catal. Sci. Technol., 2019, 9, 6415 DOI: 10.1039/C9CY01753D

To request permission to reproduce material from this article, please go to the Copyright Clearance Center request page.

If you are an author contributing to an RSC publication, you do not need to request permission provided correct acknowledgement is given.

If you are the author of this article, you do not need to request permission to reproduce figures and diagrams provided correct acknowledgement is given. If you want to reproduce the whole article in a third-party publication (excluding your thesis/dissertation for which permission is not required) please go to the Copyright Clearance Center request page.

Read more about how to correctly acknowledge RSC content.

Social activity

Spotlight

Advertisements