Issue 23, 2016

A self-powered photodetector based on a CH3NH3PbI3 single crystal with asymmetric electrodes

Abstract

Methylammonium lead iodide perovskite (MAPbI3) has made a re-entry into the literature nowadays for its extraordinary characteristics, such as high absorption of light, long carrier diffusion length, high carrier mobility, low trap-state density, low surface recombination velocity and ease of attainment. Here, we report a self-powered photodetector based on a CH3NH3PbI3 single crystal by employing asymmetric Au–Al electrodes. The key issue of this photodetector was the metal–semiconductor contacts, owing to the Schottky junction between them. By setting the channel length between the Au–Al electrodes to 30 μm for sufficient electron–hole pair separation and transportation, the device showed good performance under 1 sun illumination. The short-circuit photocurrent density and open-circuit voltage were 6.86 mA cm−2 and 0.7 V, respectively. The photocurrent was almost 2 orders of magnitude larger than that based on a perovskite polycrystalline film with a similar device structure. More importantly, the device could detect the lowest noticeable incident power density down to 1 × 10−8 W cm−2. Under this weak light intensity, the responsivity was as high as 0.24 A W−1 without any bias. The photoresponse also had a broadband ranging from 375 nm to 808 nm accompanied by a fast response speed.

Graphical abstract: A self-powered photodetector based on a CH3NH3PbI3 single crystal with asymmetric electrodes

Article information

Article type
Paper
Submitted
23 दिसम्बर 2015
Accepted
28 मार्च 2016
First published
29 मार्च 2016

CrystEngComm, 2016,18, 4405-4411

A self-powered photodetector based on a CH3NH3PbI3 single crystal with asymmetric electrodes

J. Ding, H. Fang, Z. Lian, J. Li, Q. Lv, L. Wang, J. Sun and Q. Yan, CrystEngComm, 2016, 18, 4405 DOI: 10.1039/C5CE02531A

To request permission to reproduce material from this article, please go to the Copyright Clearance Center request page.

If you are an author contributing to an RSC publication, you do not need to request permission provided correct acknowledgement is given.

If you are the author of this article, you do not need to request permission to reproduce figures and diagrams provided correct acknowledgement is given. If you want to reproduce the whole article in a third-party publication (excluding your thesis/dissertation for which permission is not required) please go to the Copyright Clearance Center request page.

Read more about how to correctly acknowledge RSC content.

Social activity

Spotlight

Advertisements