Issue 32, 2024

Synthesis of TiO2 nanotube arrays on 3D-printed structures for application as Fischer–Tropsch synthesis catalysts

Abstract

In this work, 3D-printed Ti6Al4V structures are used as substrates to synthesize TiO2 nanotube arrays by electrochemical anodization. These nanostructured materials are used as supports for bimetallic FeCo catalysts in Fischer–Tropsch synthesis to produce hydrocarbons from syngas. These structures are annealed to assess the influence of phase transformations in the development of TiO2 nanotubes. Field-emission scanning electron microscopy (FESEM) images of the untreated structures reveal needle-like formations in their microstructure, characteristic of Ti in its α′-phase resulting from the 3D printing process. X-ray diffraction (XRD) and energy-dispersive X-ray spectroscopy (EDXS) are used to compare the specimens before and after annealing. The results suggest that annealing at 850 °C before anodization introduces an undesirable oxide layer, impeding the formation of TiO2 nanotubes. This phenomenon is attributed to the complex crystallographic features of the phases formed during annealing, specifically Ti-β and TiO2-rutile, which prevent fluoride ions in the electrolyte from penetrating the structure. The results suggest that the optimal synthesis process is a two-step electrochemical treatment followed by low-temperature annealing at 450 °C. This sequence produces a desirable crystalline morphology due to the phase transformation from TiO2-rutile into TiO2-anatase, as shown by XRD. EDXS data shows that the fluorine content from residual ions from the anodizing solution is significantly reduced after annealing. Fischer–Tropsch catalysts are synthesized using a FeCo (2.0 wt%) active phase on the optimized TiO2 nanotube arrays and tested in a packed-bed reactor. These materials display catalytic activity, comparable to nanoparticulate TiO2 supported catalysts, with considerable selectivity for lighter hydrocarbons.

Graphical abstract: Synthesis of TiO2 nanotube arrays on 3D-printed structures for application as Fischer–Tropsch synthesis catalysts

Supplementary files

Article information

Article type
Paper
Submitted
22 फरवरी 2024
Accepted
17 जुलाई 2024
First published
17 जुलाई 2024

J. Mater. Chem. A, 2024,12, 20975-20989

Synthesis of TiO2 nanotube arrays on 3D-printed structures for application as Fischer–Tropsch synthesis catalysts

L. C. Caballero, J. S. Brindle, N. P. Ramey, S. A. Sufyan, S. K. Mohanty and M. M. Nigra, J. Mater. Chem. A, 2024, 12, 20975 DOI: 10.1039/D4TA01203H

To request permission to reproduce material from this article, please go to the Copyright Clearance Center request page.

If you are an author contributing to an RSC publication, you do not need to request permission provided correct acknowledgement is given.

If you are the author of this article, you do not need to request permission to reproduce figures and diagrams provided correct acknowledgement is given. If you want to reproduce the whole article in a third-party publication (excluding your thesis/dissertation for which permission is not required) please go to the Copyright Clearance Center request page.

Read more about how to correctly acknowledge RSC content.

Social activity

Spotlight

Advertisements