Issue 4, 2023

Microfluidic thermal flow sensor based on phase-change material with ultra-high thermal sensitivity

Abstract

A microfluidic thermal mass flow sensor based on planar micro-machining technology and a phase-change material is designed, fabricated, and characterized. The sensor configuration uses a small patch of vanadium dioxide (VO2) thin film as the sensing element closely placed in the down streaming direction of the heat source. By operating the VO2 sensor in the phase transition region, no thermal insulation structure is required due to the ultra-high thermal sensitivity in this region. The characteristic 3-order resistance change, from 290 kΩ to 290 Ω, is observed during the full heating and cooling cycles by using both substrate heating and resistive heating methods. The equivalent maximum temperature coefficient of resistance (TCR) is calculated to be −0.37 K−1 in the cooling cycle and −0.43 K−1 in the cooling and heating cycle, respectively. The sensing operation principle is determined to follow the major cooling curve to avoid falling into minor loops and to secure high TCR. The resistance of VO2 is monitored under flow rates ranging from 0 to 37.8 μL s−1 with the maximum sensitivity of 1.383%/(μL min−1). The studies presented in this research may enable the application of utilizing nonlinear metamaterial in microfluidic flow sensors with orders of magnitude improvement in sensitivity.

Graphical abstract: Microfluidic thermal flow sensor based on phase-change material with ultra-high thermal sensitivity

Article information

Article type
Paper
Submitted
24 sept. 2022
Accepted
25 nov. 2022
First published
28 nov. 2022

J. Mater. Chem. C, 2023,11, 1278-1284

Author version available

Microfluidic thermal flow sensor based on phase-change material with ultra-high thermal sensitivity

Y. Cao, T. Wang and N. Sepúlveda, J. Mater. Chem. C, 2023, 11, 1278 DOI: 10.1039/D2TC04047F

To request permission to reproduce material from this article, please go to the Copyright Clearance Center request page.

If you are an author contributing to an RSC publication, you do not need to request permission provided correct acknowledgement is given.

If you are the author of this article, you do not need to request permission to reproduce figures and diagrams provided correct acknowledgement is given. If you want to reproduce the whole article in a third-party publication (excluding your thesis/dissertation for which permission is not required) please go to the Copyright Clearance Center request page.

Read more about how to correctly acknowledge RSC content.

Social activity

Spotlight

Advertisements