Issue 40, 2015

Enhanced average thermoelectric figure of merit of n-type PbTe1−xIx–MgTe

Abstract

The thermoelectric properties of sintered samples of n-type PbTe1−xIxyMgTe (x = 0.0012–0.006; y = 0 and 1%) were investigated over the temperature range of 300 K to 900 K. Scanning electron microscopy revealed two different length scales of grains in samples with higher I and MgTe contents, while a homogenous microstructure for samples with a lower dopant content. Transmission electron microscopy revealed ubiquitous spherical nanoprecipitates in PbTe1−xIx with MgTe and nanoscale disk like precipitates in both, PbTe1−xIx with and without MgTe. The nanostructured PbTe showed higher Seebeck coefficients than expected values. We also observed a slower rate of increase in the electrical resistivity with rising temperature in PbTe1−xIxyMgTe below ∼550 K, leading to a higher thermoelectric power factor. The nanostructures and mixed microstructures scatter phonons, reducing the lattice thermal conductivity as low as 0.4 W K−1 m−1 at 600 K. A high ZT of 1.2 at 700 K was achieved as well as a high average ZT of 0.8 was observed in PbTe0.996I0.004–1 mol% MgTe for a cold-side temperature of 303 K and a hot-side temperature of 873 K.

Graphical abstract: Enhanced average thermoelectric figure of merit of n-type PbTe1−xIx–MgTe

Supplementary files

Article information

Article type
Paper
Submitted
05 jun. 2015
Accepted
31 jul. 2015
First published
03 ago. 2015

J. Mater. Chem. C, 2015,3, 10401-10408

Author version available

Enhanced average thermoelectric figure of merit of n-type PbTe1−xIx–MgTe

P. Jood, M. Ohta, M. Kunii, X. Hu, H. Nishiate, A. Yamamoto and M. G. Kanatzidis, J. Mater. Chem. C, 2015, 3, 10401 DOI: 10.1039/C5TC01652E

To request permission to reproduce material from this article, please go to the Copyright Clearance Center request page.

If you are an author contributing to an RSC publication, you do not need to request permission provided correct acknowledgement is given.

If you are the author of this article, you do not need to request permission to reproduce figures and diagrams provided correct acknowledgement is given. If you want to reproduce the whole article in a third-party publication (excluding your thesis/dissertation for which permission is not required) please go to the Copyright Clearance Center request page.

Read more about how to correctly acknowledge RSC content.

Social activity

Spotlight

Advertisements