Integration of aerobic oxidation and intramolecular asymmetric aza-Friedel–Crafts reactions with a chiral bifunctional heterogeneous catalyst

A chiral heterogeneous material was prepared and evaluated as a bifunctional catalyst for the sequential aerobic oxidation-asymmetric intramolecular aza-Friedel–Crafts reaction.


Introduction
Multicatalyst-promoted asymmetric tandem reactions 1 are an emerging subset in the family of one-pot processes 2 that can provide access to complex organic substrates of high enantiopurity in an efficient and practical manner. Despite the promise of these reactions, one of the major challenges that has limited their development is the problem associated with catalyst incompatibility. A potential strategy to overcome this obstacle is by applying the principle of site separation to prevent mutual deactivation of catalysts, and successful tandem asymmetric processes have been achieved with chiral catalysts immobilized or encapsulated on polymers 3 and sol-gel materials. 4 Another challenge facing multicatalyst-promoted tandem reactions is the unselective interaction of starting materials and reaction intermediates with the catalysts to generate unwanted byproducts. While it is difficult to achieve catalyst selectivity in one-pot reaction process, the use of heterogeneous catalysts in continuous-ow systems is a potential solution to overcome this problem. 5 Our group has a long-standing interest in the immobilization of metal nanoparticles (NPs) onto polymer supports 6 and its application to tandem oxidation processes (TOPs) with oxygen gas as the terminal oxidant. 7 Previously, we reported the fabrication of a layered heterogeneous bifunctional chiral catalyst consisting of Au/Pd NPs and a Jørgensen-Hayashi-type organocatalyst supported on separate polymeric materials (PI(Au/Pd)-CO, polymer-incarcerated Au/Pd NP-coated organocatalyst), and its application as a catalyst for the sequential aerobic oxidation-asymmetric Michael reaction of primary allylic alcohols and dibenzyl malonate (Scheme 1a). 3c While we were able to demonstrate that our fabrication method prevented catalyst deactivation between the Au/Pd NPs and the chiral organocatalyst to enable the asymmetric TOP, it was discovered that the chiral secondary amine catalyst was deactivated under aerobic conditions and that the heterogeneous catalyst could not be reused. Based on our preliminary experimental studies and related literature, 8 we concluded that the use of chiral heterogeneous secondary amines as organocatalysts for asymmetric TOPs was not a viable strategy due to the propensity of the covalent intermediates to undergo aerobic oxidation and become degraded. Therefore, we hypothesized that the use of chiral organocatalysts which activate the organic substrates through non-covalent interactions would lead to Scheme 1 Chiral bifunctional heterogeneous catalysts for TOPs. a more robust heterogeneous system that could be recovered and reused even under aerobic conditions.
Over the past decade, chiral phosphoric acids (CPAs) have been shown to be highly efficient catalysts for a wide range of asymmetric transformations. 9,10 Of particular note is their ability to activate imine derivatives, via hydrogen bonding or ion pair interactions (non-covalent interactions), and to promote high levels of stereoinduction of the prochiral electrophiles. Based on these considerations, we rationalized that CPAs might represent the ideal chiral component for a recyclable heterogeneous catalyst that could facilitate asymmetric TOPs. Herein, we report the preparation of a heterogeneous chiral bifunctional catalyst, consisting of Au/Pd NPs and a CPA, and its application to the sequential aerobic oxidation-asymmetric aza-Friedel-Cras (FC) reaction (Scheme 1b).

Results and discussion
We began our investigations by examining the feasibility of a TOP that integrated aerobic oxidation with the aza-FC reaction, using benzyl alcohol (1a) and N-aminoethylpyrrole (2a) as model substrates and PI/CB-Au/Pd and p-toluenesulfonic acid as co-catalysts (Scheme 2, eqn (1)). It was found that the expected piperazine 3a was not obtained under our initial conditions. This was unexpected given that control studies showed that both the aerobic oxidation of 1a and the aza-FC reaction between 2a and benzaldehyde proceeded with good yields under these initial conditions. 11 It was later revealed that the aerobic oxidation of 1a did not occur in the presence of 2a, most likely due to the strong coordination of the primary amine moiety of 2a to the Au/Pd NPs, causing catalyst deactivation. To overcome this limitation, we found that performing the TOP through a one-pot, sequential addition process, in which the aerobic oxidation of 1a was allowed to proceed prior to the addition of 2a, was key to successfully obtaining 3a. Optimization of the aerobic oxidation step and the asymmetric TOP using (S)-3,3 0 -bis(2,4,6-triisopropylphenyl)-1,1 0 -binaphthyl-2,2 0diyl hydrogenphosphate ((S)-TRIP) 12 as the CPA was performed in order to improve the yield and enantioselectivity of the desired chiral piperazine 3a. It was found that water was essential to promote the aerobic oxidation of 1a, while the introduction of BnSCH 3 as an additive to deactivate the Au/Pd NPs was important to prevent oxidation of 3a to its imine form. Based on these two major modications, the asymmetric TOP proceeded well to deliver chiral piperazine 3a in high yield and enantioselectivity (Scheme 2, eqn (2)).
With these results in hand, we began the process of fabricating chiral bifunctional heterogeneous catalysts that would be capable of facilitating the sequential aerobic oxidation-asymmetric aza-FC reaction. We began by developing a reliable synthetic route for (S)-TRIP-type monomer 4, 13 and then utilized this as a chiral feedstock to construct the chiral composite material 8 through a pseudo-suspension co-polymerization method (Fig. 1a). With this heterogeneous bifunctional chiral catalyst in hand, we examined the asymmetric TOP between benzyl alcohol (1a) and N-aminoethylpyrrole 2a (Scheme 3). It was found that aer slight modication of the optimized reaction conditions previously determined for the combined catalyst system of PI/CB-Au/Pd and (S)-TRIP, the desired piperazine 3a could be obtained in excellent yield and enantioselectivity. We also examined our model reaction using the layered heterogeneous catalyst 10 with inversed placement of the Au/Pd NPs and CPA (Fig. 1c), and it was found to catalyze the asymmetric TOP with similar results (85%, 88% ee of 3a).
Aer establishing the optimal reaction conditions for the sequential aerobic oxidation-asymmetric aza-FC reaction, we examined the substrate scope for this one-pot process (Table 1). It was found that substituted benzyl alcohols 1a-h, bearing electron-donating substituents, could be utilized for the Scheme 2 Reaction integration of aerobic oxidation with the aza-FC reaction. asymmetric TOP to furnish the desired chiral piperazines 3a-h in good yields and enantioselectivities (entries 1-8). On the other hand, when we examined 4-uorobenzyl alcohol (1i) as a substrate, only a trace amount of the expected product 3i was detected under the current reaction conditions. Control studies revealed that the origin of this problem was the aerobic oxidation step, and we found that Au/Pt NPs in DCM : H 2 O (1 : 1) were more effective for the aerobic oxidation of benzyl alcohols possessing electron-withdrawing substituents. Thus, we prepared a new chiral bifunctional heterogeneous catalyst, IOC-PI/CB(Au/Pt) 11, and found that this new chiral composite material could effectively catalyze the sequential oxidationasymmetric aza-FC reaction for 4-substituted benzyl alcohols with a wide range of functional groups, such as F, Cl, CF 3 , CO 2 Me and CN, to furnish the corresponding chiral piperazines 3i-n in good yields and enantioselectivities (entries [9][10][11][12][13][14]. We also examined the asymmetric TOP with methyl substituted N-aminoethylpyrroles 2b-c, and it was found that these substrates were also suitable, providing chiral bicyclic heterocycles 3o-p with high yields and enantioselectivities (entries 15 and 16).
Finally, we examined the possibility of recycling our chiral bifunctional heterogeneous catalyst, and found that it could be recovered and reused several times without signicant loss of yield or enantioselectivity for the asymmetric TOP with benzyl alcohol 1a and N-aminoethylpyrrole 2a as substrates (Scheme 4). The key to recycling the heterogeneous catalyst was the treatment of the spent IOC-PI/CB(Au/Pd) 8 with an aqueous solution of H 2 O 2 to remove BnSCH 3 and reactivate the Au/Pd NP catalyst.

Conclusions
In conclusion, we have developed a new chiral bifunctional heterogeneous catalyst, composed of metal NPs and CPAs, that was capable of facilitating the sequential one-pot aerobic oxidation-intramolecular asymmetric aza-FC reaction to provide chiral 1,2,3,4-tetrahydropyrrolo[1,2-a]pyrazines 3a-p in high yields and enantioselectivities. Interestingly, we found a chemical system (H 2 O 2 /BnSCH 3 ) to switch on/off the catalytic activity 14 of the Au/Pd and Au/Pt NPs. By controlling the catalytic activity of the heterogeneous catalyst through the use of a chemical modier, the undesired oxidation of chiral piperazines 3a-p was avoided, and the facile reactivation of the deactivated catalyst allowed the chiral composite material to be recovered and reused several times without signicant losses in yield or enantioselectivity of the desired product 3a. Moreover, we were able to demonstrate that heterogeneous CPAs could retain their catalytic ability in the presence of metal NPs under oxidative conditions (O 2 and H 2 O 2 ). Further investigations into the use of these robust chiral heterogeneous catalysts in other types of asymmetric TOPs are currently underway in our laboratory.