Issue 16, 2016

Electrochemically fabricated gold dendrites with underpotential deposited silver monolayers for a bimetallic SERS-active substrate

Abstract

With electrochemical deposition, cysteine-directed crystalline gold dendrites (Au-Ds) on glassy carbon electrodes were fabricated. The Au-Ds surfaces were further modified with Ag adatoms by underpotential deposition (UPD) for Ag-covered Au-Ds (Ag–Au-Ds). The Ag–Au-Ds possessed a hierarchical architecture comprising trunks, branches, and nanoleaves for a threefold-symmetry, resulting in a high density of sharp tips and edges for hot spots of surface-enhanced Raman scattering (SERS). Prominent SERS was observed with p-nitrothiophenol (p-NTP) adsorption onto either Au-Ds or Ag–Au-Ds, for a best p-NTP detection limit down to 5–10 nM at 785 nm laser excitation. However, at specific 633 nm laser excitation, SERS with p-NTP adsorption on Ag–Au-Ds exhibited a three-fold higher enhancement over that measured for p-NTP adsorbed on unmodified Au-Ds, suggesting an increased chemical SERS enhancement with the Ag–p-NTP bonding. Furthermore, adsorption isotherms of p-NTP with Au-Ds and Ag–Au-Ds adsorption in solution are established from solution p-NTP-concentration dependent SERS; from which, comparable binding constants of p-NTP to Au-Ds and Ag–Au-Ds are extracted.

Graphical abstract: Electrochemically fabricated gold dendrites with underpotential deposited silver monolayers for a bimetallic SERS-active substrate

Supplementary files

Article information

Article type
Paper
Submitted
17 Dec 2015
Accepted
25 Jan 2016
First published
27 Jan 2016

RSC Adv., 2016,6, 13185-13192

Electrochemically fabricated gold dendrites with underpotential deposited silver monolayers for a bimetallic SERS-active substrate

Y. Lai, S. Kuo, Y. Hsieh, Y. Tai, W. Hung and U. Jeng, RSC Adv., 2016, 6, 13185 DOI: 10.1039/C5RA27020K

To request permission to reproduce material from this article, please go to the Copyright Clearance Center request page.

If you are an author contributing to an RSC publication, you do not need to request permission provided correct acknowledgement is given.

If you are the author of this article, you do not need to request permission to reproduce figures and diagrams provided correct acknowledgement is given. If you want to reproduce the whole article in a third-party publication (excluding your thesis/dissertation for which permission is not required) please go to the Copyright Clearance Center request page.

Read more about how to correctly acknowledge RSC content.

Social activity

Spotlight

Advertisements