Issue 26, 2014

Observation of magnetoelectric coupling and local piezoresponse in modified (Na0.5Bi0.5)TiO3–BaTiO3–CoFe2O4 lead-free composites

Abstract

Lead-free particulate multiferroic composites of [0.94(Na0.5Bi0.5)TiO3–0.06 BaTiO3]:(Co0.6Zn0.4)(Fe1.7Mn0.3)O4 were synthesized and magnetoelectric (ME) properties were studied. X-ray diffraction and microstructural studies indicated the formation of a two-phase composite system without any impurities. The shift of Raman modes corresponding to ferroelectric and ferrite phases was assigned to the induced strain amid the formation of a two-phase system, in relation to the fraction of each phase in the samples. A strong local piezoresponse and hysteresis loops observed for composites established the ferroelectric properties at a nanoscale. Magnetostriction measurements revealed values of λ11 = −10.4 and λ12 = 5.3 ppm and piezomagnetic coefficient dλ11/dH = −0.0087 ppm Oe−1 at 0.45 kOe for a composite with a ferrite concentration of 35 mol%. A maximum change of 18.5% in magnetization after electrical poling indicates a strong magnetoelectric response of the present composites followed by a direct ME coefficient of 8.2 mV cm−1 Oe−1. Our studies point to the fact that the present multiferroic composites having strong ME coupling are useful for lead-free electronic applications.

Graphical abstract: Observation of magnetoelectric coupling and local piezoresponse in modified (Na0.5Bi0.5)TiO3–BaTiO3–CoFe2O4 lead-free composites

Article information

Article type
Paper
Submitted
31 Mar 2014
Accepted
29 Apr 2014
First published
01 May 2014

Dalton Trans., 2014,43, 9934-9943

Author version available

Observation of magnetoelectric coupling and local piezoresponse in modified (Na0.5Bi0.5)TiO3–BaTiO3–CoFe2O4 lead-free composites

E. V. Ramana, F. Figueiras, M. P. F. Graça and M. A. Valente, Dalton Trans., 2014, 43, 9934 DOI: 10.1039/C4DT00956H

To request permission to reproduce material from this article, please go to the Copyright Clearance Center request page.

If you are an author contributing to an RSC publication, you do not need to request permission provided correct acknowledgement is given.

If you are the author of this article, you do not need to request permission to reproduce figures and diagrams provided correct acknowledgement is given. If you want to reproduce the whole article in a third-party publication (excluding your thesis/dissertation for which permission is not required) please go to the Copyright Clearance Center request page.

Read more about how to correctly acknowledge RSC content.

Social activity

Spotlight

Advertisements