Issue 8, 2010

Lanthanide doped silicananoparticles applied to multiplexed immunoassays

Abstract

Luminescent samarium (Sm) and europium (Eu) doped silica nanoparticles (SiO2 NPs) were investigated for use in multiple target immunoassays. Particles with a diameter of 40 ± 10 nm were synthesized and applied to multiplexed immunoassays in a single well of an assay plate. The luminescent behavior of the lanthanide doped NPs was compared to conventional dyes in solution and in surface confined model immunoassays against two analytes. Luminescence from the dyes and NPs was detected with an imaging spectroscopic system and this could be processed with a simple least squares procedure. In solution, NPs exhibited linear mixing behaviour while conventional fluorescent dyes required careful control to solution conditions, particularly pH. A conventional dye system consisting of FITC and Cy3 applied to a two analyte model system resulted in up to 70% energy transfer from FITC to Cy3 under conditions of high surface coverage. This made quantitative analysis intractable for unknown samples. The lanthanide doped silica nanoparticles responded well to both analytes (<5% relative std. dev.). The results demonstrate that NPs provide alternatives to conventional dyes due to low susceptibility to pH and related solution conditions, absence of energy transfer, single excitation wavelength range, and high stokes shift. These properties allowed quantitative analysis of multiple analytes in the same well.

Graphical abstract: Lanthanide doped silica nanoparticles applied to multiplexed immunoassays

Article information

Article type
Paper
Submitted
09 Apr 2010
Accepted
03 Jun 2010
First published
23 Jun 2010

Analyst, 2010,135, 2132-2138

Lanthanide doped silica nanoparticles applied to multiplexed immunoassays

K. Murray, Y. Cao, S. Ali and Q. Hanley, Analyst, 2010, 135, 2132 DOI: 10.1039/C0AN00222D

To request permission to reproduce material from this article, please go to the Copyright Clearance Center request page.

If you are an author contributing to an RSC publication, you do not need to request permission provided correct acknowledgement is given.

If you are the author of this article, you do not need to request permission to reproduce figures and diagrams provided correct acknowledgement is given. If you want to reproduce the whole article in a third-party publication (excluding your thesis/dissertation for which permission is not required) please go to the Copyright Clearance Center request page.

Read more about how to correctly acknowledge RSC content.

Social activity

Spotlight

Advertisements