Issue 11, 2000

Oscillatory and ion-correlation forces observed in direct force measurements between silica surfaces in concentrated CaCl2 solutions

Abstract

The force between silica spheres and naturally oxidised silicon wafer has been measured in calcium chloride solutions at concentrations between 1 and 5 M using an atomic force microscope. An oscillatory force, consistent in periodicity with the expulsion of layers of ions, was found to overlay the expected van der Waals force. The extent and magnitude of the oscillations increased markedly with electrolyte concentration. Measured pull-off forces point to the oscillatory force minima being much larger in magnitude than the maxima, and appears to confirm the existence of ion correlation forces, possibly resulting from shared hydration waters forming an attractive network. Forces were also measured in 1 M NaCl solution. A monotonic repulsion was observed at short-range, in contrast with the ‘ hard-wall’ of Ca2+ ions observed in 1 M CaCl2 before expulsion at a force of 3 mN m−1. These observations suggest that calcium ions are attracted to the surface strongly enough to disrupt the hydration of the surface and/or the ions, whereas sodium ions are not. The results demonstrate a simple methodology for the direct investigation of ion-specific surface forces at high salt concentrations.

Article information

Article type
Paper
Submitted
01 Mar 2000
Accepted
10 Apr 2000
First published
15 May 2000

Phys. Chem. Chem. Phys., 2000,2, 2623-2628

Oscillatory and ion-correlation forces observed in direct force measurements between silica surfaces in concentrated CaCl2 solutions

M. L. Fielden, R. A. Hayes and J. Ralston, Phys. Chem. Chem. Phys., 2000, 2, 2623 DOI: 10.1039/B001672L

To request permission to reproduce material from this article, please go to the Copyright Clearance Center request page.

If you are an author contributing to an RSC publication, you do not need to request permission provided correct acknowledgement is given.

If you are the author of this article, you do not need to request permission to reproduce figures and diagrams provided correct acknowledgement is given. If you want to reproduce the whole article in a third-party publication (excluding your thesis/dissertation for which permission is not required) please go to the Copyright Clearance Center request page.

Read more about how to correctly acknowledge RSC content.

Social activity

Spotlight

Advertisements