Open Access Article
This Open Access Article is licensed under a Creative Commons Attribution 3.0 Unported Licence
Correction: An excellent humidity sensor based on In–SnO2 loaded mesoporous graphitic carbon nitride
Ritu
Malik
a,
Vijay K.
Tomer
*b,
Vandna
Chaudhary
c,
Manjeet S.
Dahiya
d,
Anshu
Sharma
e,
S. P.
Nehra
c,
Surender
Duhan
d and
Kamalakannan
Kailasam
*b
aDepartment of Applied Physics, Mahavir Swami Institute of Technology, Sonepat, Haryana-131001, India
bInstitute of Nano Science & Technology (INST), Mohali, Punjab, 160062 India. E-mail: vjtomer@gmail.com; kamal@inst.ac.in
cCenter of Excellence for Energy and Environmental Studies, D. C. R. University of Science & Technology, Murthal, Sonepat, Haryana, 131039 India
dDepartment of Materials Science & Nanotechnology, D. C. R. University of Science & Technology, Murthal, Sonepat, Haryana, 131039 India
eDepartment of Physics, Indian Institute of Technology Delhi, New Delhi, 110016, India
First published on 21st September 2020
Abstract
Correction for ‘An excellent humidity sensor based on In–SnO2 loaded mesoporous graphitic carbon nitride’ by Ritu Malik et al., J. Mater. Chem. A, 2017, 5, 14134–14143, DOI: 10.1039/C7TA02860A.
The authors regret that HRTEM images in Fig. 3a–i and the corresponding mapping images in Fig. 3j–n are incorrect. New samples of the materials have been prepared and the corrected version of Fig. 3 is provided below. We confirm that the corresponding text and caption will remain the same as in the original version. The authors confirm that these errors do not alter the results or discussions of the article and express sincere apologies for any inconvenience caused.
 | ||
| Fig. 1 The HRTEM images showing uniform channels with long range order for (a–c) KIT-6, (d–f) meso-CN and (g–i) In–SnO2/meso-CN. (j–n) The elemental mapping of In–SnO2/meso-CN obtained from the HRTEM image shown in the inset of (i). The XPS analysis of In–SnO2/meso-CN for (o) C 1s, (p) N 1s, (q) Sn 3d, (r) O 1s and (s) In 3d. | ||
In addition, incorrect TEM images were presented in Fig. S1a–c and therefore correct images have been provided in the revised supporting information.
The Royal Society of Chemistry apologises for these errors and any consequent inconvenience to authors and readers.
| This journal is © The Royal Society of Chemistry 2020 |