Open Access Article
Yuepeng Cao,
Zhenhua Gao,
Junchen Li,
Xiaojing Bi,
Ling Yuan,
Chengxin Pei,
Yongbiao Guo
* and
Enxue Shi*
State Key Laboratory of NBC Protection for Civilian, Beijing 102205, P. R. China. E-mail: van87120@126.com; exshi@sina.com
First published on 11th August 2020
A regioselective O/C phosphorylation of α-chloroketones with trialkyl phosphites was performed for the first time, which employed solvent-free Perkow reaction and NaI-assisted Arbuzov reaction under mild conditions respectively. Versatile enol phosphates were prepared in good to excellent yields as well as β-ketophosphinates.
:
1) for Perkow reaction was obtained in p-xylene with yields of 45%. Based on the knowledge of the mechanism of Perkow reaction, we assumed that using 1-chloropropan-2-one 2a instead of 2a′ should improve the selectivity. Unfortunately, the reaction became very sluggish (entry 12). But unexpectedly, the solvent-free reaction of 1a and 2b gave the 3a not only in good yield but with excellent selectivity (entry 13). Moreover, when lowering the temperature just from 40 to 30 °C, the regioselectivity could increase to as high as 94
:
1 (entry 14) though the reaction became some lower reactive (50% yield vs. 70%). Raising the reaction temperature to 50 °C or 90 °C, which prospectively improved the reaction rate significantly, would obviously decrease the selectivity (entries 15 and 16). Further control experiments revealed that the optimized reaction conditions should be usage of 1.2 equiv. of 1a, providing the target compound in 80% yield with 50
:
1 regioselectivity (entry 17).
| Entry | X | Temp. (°C) | Solvent | T (h) | Yield (%) of 3ab | 3a : 4ab |
|---|---|---|---|---|---|---|
| a Reaction conditions: 1a (2.4 mmol), 2a or 2a′ (2 mmol), in neat or 5 mL solvent.b Yield and regioselectivity of 3a and 4a were determined by 1H NMR.c 1.2 equiv. of 1a used.d 1.5 equiv. of 1a used. | ||||||
| 1 | Br | 40 | — | 3 | 50 | 1 : 1 |
| 2 | Br | 40 | p-Xylene | 72 | 45 | 7 : 1 |
| 3 | Br | 40 | o-Xylene | 72 | 45 | 6.5 : 1 |
| 4 | Br | 40 | m-Xylene | 72 | 40 | 4.5 : 1 |
| 5 | Br | 40 | PhMe | 72 | 30 | 4.5 : 1 |
| 6 | Br | 40 | PhH | 72 | 15 | 2.5 : 1 |
| 7 | Br | 40 | CH2Cl2 | 72 | 50 | 3 : 1 |
| 8 | Br | 40 | Et2O | 72 | 15 | 2 : 1 |
| 9 | Br | 40 | THF | 72 | 20 | 2 : 3 |
| 10 | Br | 40 | 1,4-Dioxane | 72 | 30 | 2 : 3 |
| 11 | Br | 40 | Acetone | 72 | 25 | 2 : 5 |
| 12 | Cl | 40 | p-Xylene | 36 | Trace | — |
| 13 | Cl | 40 | — | 36 | 70 | 50 : 1 |
| 14 | Cl | 30 | — | 36 | 50 | 94 : 1 |
| 15 | Cl | 50 | — | 24 | 73 | 28 : 1 |
| 16 | Cl | 90 | — | 10 | 70 | 12 : 1 |
| 17c | Cl | 40 | — | 36 | 80 | 50 : 1 |
| 18d | Cl | 40 | — | 36 | 80 | 50 : 1 |
Under the optimized conditions, the scope of the regioselective Perkow reaction of trimethyl phosphite 1a and various α-chloroketone (2a–k) was investigated (Scheme 2). Generally, both the steric and electronic substituents on aliphatic and aromatic α-chloroketones seem to have negligible effects on the regioselectivity. Substrates bearing either an electron-donating (OMe) or electron-withdrawing groups (Br, Cl and F) at the 4-position of the phenyl ring were all converted to their corresponding products 3b–3g in excellent yields (88% to 95%) with high regioselectivities (50
:
1 to >99
:
1), albeit the α-chloroketone with electron-donating OMe required a higher ratio of 1a
:
2b (3
:
1). However, the electronic effects may have great influence on the reaction rate leading to the reaction times of α-chloroketone with electron-withdrawing group (Ph, Br, Cl and F) significantly reduced to 10 h. But the positions of substituents on phenyl ring showed almost no effect (entry 3h and 3i vs. 3f). It is worth noting that the electronic substituents on the halocarbon C could significantly determine the reaction efficiency as shown by chloro-substituted (3l) and 2,2-difluoro-substituted (3m) substrates with only 2 h and 1 h reaction time, while the methyl-substituted substrates (3j) and (3k) with 48 h and 24 h reaction time. For cyclical substrates, the corresponding products were obtained in excellent regioselectivities but much different yields (3n) and (3o) under the optimized conditions. Gratifyingly, when the reaction temperature was increased 90 °C, 81% yield without loss of regioselectivity could be achieved after 48 h reaction time (3o).
![]() | ||
| Scheme 2 Scope of α-haloketones.a aReaction conditions: 1a (2.4 mmol), 2a–o (2 mmol), 40 °C, 24 h. b1a (6 mmol). c10 h. d2 h. e1 h. f90 °C, 48 h. | ||
Encouraged by those results, we next optimized the Arbuzov reaction conditions (Table 2). Although compared with 1-chloropropan-2-one and 1-bromopropan-2-one, 1-iodopropan-2-one exhibited superior regioselectivity (25
:
1) of Arbuzov reaction, the yield of 4a was poor (entry 3 vs. entries 1 and 2) due to that 1-iodopropan-2-one would decompose under solvent-free conditions. However, since higher-polar solvent of actone exhibited good regioselectivity of Arbuzov reaction (Table 1, entry 11), we hypothesized that if 1-iodoketone could be generated in situ by treatment of 2a with NaI in acetone (Finkelstein reaction20–23), which may be beneficial to the conversion favouring Arbuzov reaction. Following experiments verified our assumption that 4a was obtained in 85% yield with 26
:
1 regioselectivity (entry 5). Further screening of reaction temperature revealed that 50 °C was the most satisfactory condition (entry 7, 85%, 35
:
1).
| Entry | X | Temp. (°C) | NaI | Solvent | T (h) | Yield (%) of 4ab | 4a : 3ab |
|---|---|---|---|---|---|---|---|
| a Reaction conditions: 1a (2.4 mmol), 2a, 2a′ or 2a′′ (2 mmol), NaI (0 or 2 mmol) neat or 5 mL acetone, 30–60 °C, 2–30 h.b Yield and regioselectivity of 4a and 3a were determined by 1H NMR. | |||||||
| 1 | Cl | 40 | — | — | 36 | <2 | 1 : 50 |
| 2 | Br | 40 | — | — | 3 | 50 | 1 : 1 |
| 3 | I | 40 | — | — | 2 | 25 | 25 : 1 |
| 4 | Br | 40 | — | Acetone | 30 | 63 | 5 : 2 |
| 5 | Cl | 40 | 1 eq. | Acetone | 4 | 85 | 26 : 1 |
| 6 | Cl | 45 | 1 eq. | Acetone | 2 | 84 | 28 : 1 |
| 7 | Cl | 50 | 1 eq. | Acetone | 2 | 85 | 35 : 1 |
| 8 | Cl | 60 | 1 eq. | Acetone | 2 | 87 | 24 : 1 |
With the optimized reaction conditions in hand, the scope of this reaction was explored with trimethyl phosphite 1a and various α-chloroketones (2a–k) to prepare β-ketophosphonates 4a–k (Scheme 3). Substrates bearing either an electron-donating (OMe) or electron-withdrawing groups (Br, Cl and F) at the 4-position on the phenyl ring were converted to their corresponding Arbuzov products 4b–4i in good to excellent yields (67% to 93%) and moderate to excellent regioselectivities (5
:
1 to 84
:
1). Notably, the electronic effects and the positions of substituents on the phenyl ring have some effect on the selectivity. For example, electron-donating and 4-position groups on the phenyl ring were more beneficial (4b vs. 4e–g and 4f vs. 4h,i) for Arbuzov reaction. Encouraged by these results, we next tested the generality of the reaction regarding the substituent groups on the halocarbon of α-haloketones. However, the reaction proceeded sluggishly and only trace of the product 4j–4o were detected. It was analyzed that the steric effects of substituents have a significantly effect on the in situ iodation reaction.
![]() | ||
| Scheme 3 Scope of α-haloketones.a aReaction conditions: 1a (2.4 mmol), 2a–k (2 mmol), NaI (2 mmol), 5 mL acetone, 50 °C, 2 h. | ||
To further extend the substrate scope, triethyl phosphite 1b and diethyl methylphosphonite 1c were examined in the regioselective Perkow
:
Arbuzov reaction system. Under the optimized conditions, triethyl phosphite gave its corresponding Perkow product 5a and Arbuzov product 6a in good yields (77% and 86%) and regioselectivities (44
:
1 and 22
:
1) respectively, which was similar to trimethyl phosphite 1a. It was noteworthy that the reaction activity of 1c was much greater than 1b (1 h vs. 24 h) giving product 5b in 85% yield with very high regioselectivity (>99
:
1). However, the substrate 1c gave disappointingly trace amount of 6b under the standard reaction conditions of Arbuzov reaction (Scheme 4).
:
i-PrOH (20
:
1)] to obtain 3 as colorless oil or white solid.
:
i-PrOH (10
:
1)] to obtain 4 as colorless oil or white solid.
Footnote |
| † Electronic supplementary information (ESI) available. See DOI: 10.1039/d0ra05140c |
| This journal is © The Royal Society of Chemistry 2020 |