Open Access Article
This Open Access Article is licensed under a Creative Commons Attribution 3.0 Unported Licence
Correction: Development and characterisation of acoustofluidic devices using detachable electrodes made from PCB
Roman
Mikhaylov
a,
Fangda
Wu
a,
Hanlin
Wang
a,
Aled
Clayton
b,
Chao
Sun
c,
Zhihua
Xie
d,
Dongfang
Liang
e,
Yinhua
Dong
f,
Fan
Yuan
g,
Despina
Moschou
h,
Zhenlin
Wu
i,
Ming Hong
Shen
j,
Jian
Yang
j,
Yongqing
Fu
k,
Zhiyong
Yang
l,
Christian
Burton
ab,
Rachel J.
Errington
b,
Marie
Wiltshire
b and
Xin
Yang
a
aDepartment of Electrical and Electronic Engineering, School of Engineering, Cardiff University, Cardiff CF24 3AA, UK
bTissue Micro-Environment Group, Division of Cancer & Genetics, School of Medicine, Cardiff University, Cardiff CF14 4XN, UK
cSchool of Life Sciences, Northwestern Polytechnical University, 710129, P.R. China
dDepartment of Civil Engineering, School of Engineering, Cardiff University, Cardiff CF24 3AA, UK
eDepartment of Engineering, University of Cambridge, Cambridge CB2 1PZ, UK
fDepartment of Neurology, Tianjin 4th Centre Hospital Affiliated to Nankai University, 300140, P.R. China
gDepartment of Biomedical Engineering, School of Engineering, Duke University, NC 27708-0281, USA
hCentre for Biosensors, Bioelectronics and Biodevices (C3Bio) and Department of Electronic & Electrical Engineering, University of Bath, Bath BA2 7AY, UK
iSchool of Optoelectronic Engineering and Instrumentation Science, Dalian University of Technology, 116023, P.R. China
jPreclinical Studies of Renal Tumours Group, Division of Cancer and Genetics, School of Medicine, Cardiff University, Cardiff CF14 4XN, UK
kFaculty of Engineering and Environment, Northumbria University, Newcastle Upon Tyne, Newcastle NE1 8ST, UK
lSchool of Mechanical Engineering, Tianjin University, 300072, P.R. China
First published on 31st July 2020
Abstract
Correction for ‘Development and characterisation of acoustofluidic devices using detachable electrodes made from PCB’ by Roman Mikhaylov et al., Lab Chip, 2020, 20, 1807–1814, DOI: 10.1039/C9LC01192G.
The authors regret that the microfluidic channel dimensions in the “PCB-SAW fabrication and experimental setup” section of the original manuscript were incorrect. The correct microfluidic channel dimensions are 15 mm × 200 μm × 60 μm for length, width and height, respectively.
The Royal Society of Chemistry apologises for these errors and any consequent inconvenience to authors and readers.
| This journal is © The Royal Society of Chemistry 2020 |