Development of an automated measurement system using a diffusion scrubber and high-performance liquid chromatography for the monitoring of formaldehyde and acetaldehyde in automotive exhaust gas

Abstract

An automated measurement system for monitoring formaldehyde (HCHO) and acetaldehyde (CH₃CHO) in automotive exhaust gas by using a diffusion scrubber in combination with high-performance liquid chromatography (HPLC) was developed. HCHO and CH₃CHO are effectively collected by the diffusion scrubber, which consists of a hydrophobic porous PTFE tube disposed concentrically within a Pyrex-glass tube and a scrubbing solution. 2,4-Dinitrophenylhydrazine is used as the scrubbing solution for trapping HCHO and CH₃CHO, which are derivatized to formaldehyde 2,4-dinitrophenylhydrazone (DNPH-HCHO) and acetaldehyde 2,4-dinitrophenylhydrazone (DNPH-CH₃CHO), respectively, with phosphoric acid as an acid catalyst. After the collection of the gas sample, the sample solution in the diffusion scrubber is injected into the HPLC system and DNPH-HCHO and DNPH-CH₃CHO are separated and determined. All measurement operations are sequenced by a programmable controller and an automated continuous measurement can be performed at 10 min intervals. The collection efficiencies of HCHO and CH₃CHO were higher than 97% at a gas flow rate of 0.2 l min^–1. The detection limit (3ς of the blank value) was 0.001 ppm v/v for HCHO and CH₃CHO for a 1.6 l gas sample volume. No interference of co-existing nitrogen dioxide (NO₂) in the collection of HCHO and CH₃CHO was observed. The average concentration of HCHO in the exhaust gas from methanol-fueled vehicles was 77.3 ppm v/v (n = 5) in the cold-phase mode when engines were first started. In the hot-phase mode, the average concentration of HCHO was 3.3 ppm v/v (n = 15). The concentrations of HCHO measured by this automated measurement system were in good agreement with those obtained using the impinger-HPLC method.

References

1. E. Grosjean, E. L. Williams, II and D. Grosjean, J. Air Waste Manage. Assoc., 1993, 43, 469.
2. P. Carlier, H. Hannach and G. Mouvier, Atmos. Environ., 1986, 20, 2079.
3. M. Possanzini, V. Di Palo, M. Petricca, R. Fratarcangeli and D. Brocco, Atmos. Environ., 1996, 30, 3757.
4. WHO, Air Quality Guidelines for Europe, WHO European Series No. 23, WHO Copenhagen, 1987.
5. R. L. Tanner, A. H. Miguel, J. B. Andrade, J. S. Gaffney and G. E. Streit, Environ. Sci. Technol., 1988, 22, 1026.
6. R. L. Williams, F. Lipari and R. A. Potter, J. Air Waste Manage. Assoc., 1990, 40, 747.
7. J. R. Barker, A. A. Herstrom and D. T. Tingey, Water Air Soil Pollut., 1996, 86, 71.
8. F. Lipari and S. J. Swarin, J. Chromatogr., 1982, 247, 297.
9. J. B. Andrade and A. H. Miguel, Int. J. Environ. Anal. Chem., 1985, 21, 229.
10. F. Lipari and S. Swarin, Environ. Sci. Technol., 1985, 19, 70.
11. P. A. Gabel, J. Air Waste Manage. Assoc., 1990, 40, 296.
12. L. P. Haack, D. L. LaCourse and T. J. Korniski, Anal. Chem., 1986, 58, 68.
13. T. Mori, Jidosha Kenkyu, 1995, 17, 339.
14. A. H. J. Grömping and K. Cammann, J. Autom. Chem., 1996, 18, 121.
15. P. K. Dasgupta, Adv. Chem. Ser., 1993, 232, 41.
16. W. Frenzel, Anal. Chim. Acta, 1994, 291, 305.
17. Q. Fan and P. K. Dasgupta, Anal. Chem., 1994, 66, 55l.
18. W. MacKays and M. E. Craford, Convective Heat and Mass Transfer, McGraw-Hill, New York, 2nd edn., 1980, pp. 66–68.
19. H. Tuss, V. Neitzert, W. Seiler and R. Neeb, Fresenius' J. Anal. Chem., 1982, 312, 613.
20. W. R. Cofer, III and R. A. J. Edahl, Atmos. Environ., 1986, 20, 979.
21. E. Cotsaris and B. C. Nicholson, Analyst, 1993, 118, 265.
22. P. G. Gormley and M. Kennedy, Proc. R. Ir. Acad., 1949, 52, 163.
23. F. Cecchini and M. Possanzini, Anal Lett., 1985, 18, 681.
24. C. R. Winkler and C. Y. Lee, Ind. Eng. Chem., 1955, 47, 1253.
25. E. A. Betterton and M. R. Hoffmann, Environ. Sci. Technol., 1988, 22, 1415.
26. U. Karst, N. Binding, K. Cammann and U. Witting, Fresenius' J. Anal. Chem., 1993, 345, 48.
27. S. E. Schwartz and W. H. White, in Advances in Environmental Science and Engineering, ed. J. R. Pfafflin and E. N. Ziegler, Gordon and Breach, New York, 1984, vol. 4, pp. 1–45.
28. Japanese Industrial Standards (JIS), K 0303, Japanese Industrial Standards Committee, Japanese Standards Association, 1993.