Development of a method for the determination of low contents of asbestos fibres in bulk material

Abstract

Asbestos is a category 1 carcinogen under the EU classification, but in the absence of a method to quantify asbestos in a matrix at the 0.1% level, there has been a delay in implementing relevant directives to asbestos. An analytical scheme for identification and quantification of asbestos using polarised light microscopy (PLM) and phase contrast optical microscopy (PCM) has now been developed. When used on artificial mixtures by an experienced laboratory, it achieved the required target performance, at 0.1% asbestos concentration by mass in a bulk sample, to obtain a result, which with 90% probability, is correct within a factor of two. The method of identification by PLM and quantification by PCM has been assessed by interlaboratory comparisons. The method begins with an initial identification using PLM, and depending on asbestos type and matrix a combination of preparation procedures are used to produce the analytical filter. A gentle comminution method was used which reduces the risk of overmilling. The asbestos mass percentage on the filter is quantified using PCM in combination with a PLM attachment for identification of possible non-asbestos fibres. The final method is supported by efficient methods for fibre identification for size determination and calculation of total fibre volume. A statistical analysis of mass concentration estimates was made and the effect of preferred orientation of fibres on the analytical filter was quantified.

References

1. Ambient Air—Determination of Asbestos Fibres—Direct Transfer Transmission Electron Microscopy Method. International Standards Organisation ISO DP10312: 1995.
2. T. Schneider, L. S. T. Davies, G. Burdett, J. Tempelman, S. Puledda, O. Jørgensen, D. Buchanan and L. Paoletti, Development of a Method for the Determination of Low Contents of Fibres in Bulk Material. European Community Contract No MAT1-CT93-0003. Final report. National Institute of Occupational Health, Copenhagen, Denmark, 1997.
3. G. Burdett, Identification of Asbestos in Bulk Materials by Polarised Light Microscopy (PLM). Final report January 1996(minor revision 7/ 1997), Health and Safety Laboratory, Broad Lane, Sheffield S3 7HQ, UK, 1997.
4. NIOSH, NIOSH Manual of Analytical Methods. US Department of Health and Human Services, National Institute for Occupational Health, Cincinnati, OH, USA, 4th edn., 1994.
5. T. Schneider, Staub Reinhalt. Luft, 1992, 52, 201.
6. T. Schneider, S. A. Sethi, L. S. T. Davies, G. Burdett and O. Jørgensen, J. Aerosol. Sci., 1997, 28, Suppl 1, S611.
7. L. S. T. Davies, D. Buchanan and C. McIntosh, 1998, to be submitted.
8. BS 5309: part 4: 1976. Methods for Sampling Chemical Products. Part 4. Sampling of Solids. British Standards Institution, London, UK, 1996.
9. J. Addison and L. S. T. Davies, Ann. Occup. Hyg., 1990, 34, 159.
10. S. Puledda and L. Paoletti, Ann. Occup. Hyg., 1994, 38, 59.
11. L. Lundgren, S. Lundström, G. Sundström, G. Bergmann and S. Krantz, Ann. Occup. Hyg., 1996, 40, 197.
12. Ambient air—Determination of Asbestos Fibres Indirect Transfer Transmission Electron Microscopy Method. International Standards Organisation, ISO 13794: 1997.
13. WHO, Determination of Airborne Fibre Number Concentrations. A Recommended Method by Phase Contrast Microscopy (Membrane Filter Method), World Health Organisation, Geneva, Switzerland, 1996.
14. D. J. Finney, Suppl. J. R. Stat. Soc., 1941, 7, 155.
15. E. S. Larsen and H. Berman, The Microscopic Determination of Nonopaque Minerals. United States Department of Interior, Geological Survey Bulletin 848, US Government Printing Office, Washington, DC, USA, 1934.
16. W. A. Deer, R. A. Howie and J. Zussman, An Introduction to the Rock Forming Minerals, Longmans, London, 1966.
17. W. E. Tröger, Optische Bestimmung der Gesteinbildenden Minerale, E. Schweizerbart'sche Verlagsbuchhandlung, Stuttgart, 1982.
18. J. W. Kelse and C. S. Thompson, Am. Ind. Hyg. Assoc. J., 1989, 50, 613.
19. A. G. Wylie, Ann. N. Y. Acad. Sci., 1983, 105.
20. A. G. Wylie, Discriminating Amphibole Cleavage Fragments from Asbestos: Rationale and Methodology Proceedings VII Pneumoconiosis Conference (Pittsburgh, Pennsylvania, USA, 23–26 August 1988), DHHS (NIOSH), Cincinnati, OH, USA, Publication No. 90-108, part II, November 1990, pp. 1065–1069.
21. F. D. Pooley and N. J. Clark, Ann. Occup. Hyg., 1979, 22, 253.
22. T. Schneider, J. Aerosol. Sci., 1993, 24, 963.
23. T. Schneider and E. Holst, J. Aerosol. Sci., 1995, 26, 127.
24. Commission Directive 67/89/EC of 5 December 1997, adaptation to Technical Progress of Directive 67/548/EEC. Official Journal of the European Communities, L343/19.
25. N. P. Crawford, P. Brown and A. J. Cowie, Ann. Occup. Hyg., 1992, 36, 59.