Jump to main content
Jump to site search

Issue 3, 1998
Previous Article Next Article

Bulk and surface analysis of a supported Pt[ndash ]MoOx–Al2O3model system in the fresh and sulfided state

Abstract

The bulk composition, structure and valence state of a model catalyst containing 3% Pt and 12% MoO3 supported on Al2O3 have been studied by X-ray diffraction (XRD), high-resolution transmission electron microscopy (HRTEM), energy dispersive X-ray (EDX) analysis, X-ray photoelectron spectroscopy (XPS) and ion scattering spectroscopy (ISS). Electron microscopy (EM) indicated that molybdenum oxide was likely to be present as a thin surface layer of MoVI as shown by EDX and XPS. MoVI was not quantitatively reduced to MoV and MoIV upon H2 treatment at 673 K. Sulfidation by H2S at 673 K produced more MoIV, mainly as MoS2 spread over the surface and/or in the pores of alumina. A constant in-depth Mo ISS signal indicated that there were larger Mo particles. Sulfur, in turn, was removed by ISS, pointing to the presence of S adspecies other than MoS2, in agreement with XPS. Pt was distributed as separate small crystallites. Reduction created almost clean metallic Pt sputtered away by ISS, indicating its very disperse character. EM, XRD and XPS confirmed that some Pt transformed to PtS upon H2S–H2 treatment, larger PtS crystallites coexisting with smaller Pt particles. A reduced catalyst was very active in cyclohexene hydrogenation; much lower activity with increased benzene selectivity was observed after sulfidation.

Back to tab navigation

Article type: Paper
DOI: 10.1039/A705948E
J. Chem. Soc., Faraday Trans., 1998,94, 459-466

  •   Request permissions

    Bulk and surface analysis of a supported Pt[ndash ]MoOx–Al2O3model system in the fresh and sulfided state

    Z. Paál, P. Te′te′nyi, M. Muhler, U. Wild, J-M. Manoli and C. Potvin, J. Chem. Soc., Faraday Trans., 1998, 94, 459
    DOI: 10.1039/A705948E

Search articles by author

Spotlight

Advertisements