Issue 10, 2024

Stabilizing a Li1.3Al0.3Ti1.7(PO4)3/Li metal anode interface in solid-state batteries with a LiF/Cu-rich multifunctional interlayer

Abstract

Li1.3Al0.3Ti1.7(PO4)3 (LATP) has attracted much attention due to its high ionic conductivity, good air stability and low cost. However, the practical application of LATP in all-solid-state lithium batteries faces serious challenges, such as high incompatibility with lithium metal and high interfacial impedance. Herein, a CuF2 composite layer was constructed at a Li/LATP interface by a simple drop coating method. CuF2 in the interlayer reacts with lithium metal in situ to form a multifunctional interface rich in Cu and LiF. The multifunctional layer not only brings about close interfacial contact between LATP and Li metal, but also effectively prevents the electrochemical reaction of LATP with Li metal, and suppresses the electron tunneling and dendrite growth at the interface. The interfacial resistance of Li/CuF2@LATP/Li symmetric batteries is significantly reduced from 562 to 92 Ω, and the critical current density is increased to 1.7 mA cm−2. An impressive stable cycle performance of over 6000 h at 0.1 mA cm−2/0.1 mA h cm−2, 2200 h at 0.2 mA cm−2/0.2 mA h cm−2 and 1600 h at 0.3 mA cm−2/0.3 mA h cm−2 is achieved. Full batteries of LiFePO4/CuF2@LATP/Li also show a high capacity retention ratio of 80.3% after 540 cycles at 25 °C. This work provides an effective and simple composite layer solution to address the interfacial problem of Li/LATP.

Graphical abstract: Stabilizing a Li1.3Al0.3Ti1.7(PO4)3/Li metal anode interface in solid-state batteries with a LiF/Cu-rich multifunctional interlayer

Supplementary files

Article information

Article type
Edge Article
Submitted
27 Nov 2023
Accepted
31 Jan 2024
First published
01 Feb 2024
This article is Open Access

All publication charges for this article have been paid for by the Royal Society of Chemistry
Creative Commons BY-NC license

Chem. Sci., 2024,15, 3730-3740

Stabilizing a Li1.3Al0.3Ti1.7(PO4)3/Li metal anode interface in solid-state batteries with a LiF/Cu-rich multifunctional interlayer

D. Ding, H. Ma, H. Tao, X. Yang and L. Fan, Chem. Sci., 2024, 15, 3730 DOI: 10.1039/D3SC06347J

This article is licensed under a Creative Commons Attribution-NonCommercial 3.0 Unported Licence. You can use material from this article in other publications, without requesting further permission from the RSC, provided that the correct acknowledgement is given and it is not used for commercial purposes.

To request permission to reproduce material from this article in a commercial publication, please go to the Copyright Clearance Center request page.

If you are an author contributing to an RSC publication, you do not need to request permission provided correct acknowledgement is given.

If you are the author of this article, you do not need to request permission to reproduce figures and diagrams provided correct acknowledgement is given. If you want to reproduce the whole article in a third-party commercial publication (excluding your thesis/dissertation for which permission is not required) please go to the Copyright Clearance Center request page.

Read more about how to correctly acknowledge RSC content.

Social activity

Spotlight

Advertisements