Issue 8, 2023

Low-power laser manufacturing of copper tracks on 3D printed geometry using liquid polyimide coating

Abstract

Silver nanoparticle photoreduction synthesis by direct laser writing is a process that enables copper micro-track production on very specific polymers. However, some important 3D printing polymers, such as acrylonitrile butadiene styrene (ABS) and acrylates, do not accept this treatment on their surface. This work presents an approach to produce copper microcircuitry on 3D substrates from these materials by using direct laser writing at low power (32 mW CW diode laser). We show that by coating a thin layer of polyimide (PI) on a 3D-printed geometry, followed by a sequence of chemical treatments and low-power laser-induced photoreduction, copper tracks can be produced using silver as catalyst. The surface chemistry of the layer through the different stages of the process is monitored by FTIR and X-ray photoelectron spectroscopy. The copper tracks are selectively grown on the laser-patterned areas by electroless copper deposition, with conductivity (1.2 ± 0.7) × 107 S m−1 and a width as small as 28 μm. The patterns can be written on 3D structures and even inside cavities. The technique is demonstrated by integrating different circuits, including a LED circuit on 3D printed photopolymer acrylate and a perovskite solar cell on an ABS 3D curved geometry.

Graphical abstract: Low-power laser manufacturing of copper tracks on 3D printed geometry using liquid polyimide coating

Supplementary files

Article information

Article type
Paper
Submitted
24 Feb 2023
Accepted
16 Mar 2023
First published
18 Mar 2023
This article is Open Access
Creative Commons BY license

Nanoscale Adv., 2023,5, 2280-2287

Low-power laser manufacturing of copper tracks on 3D printed geometry using liquid polyimide coating

M. Abdulrhman, A. Kaniyoor, C. M. Fernández-Posada, P. Acosta-Mora, I. McLean, N. Weston, M. P. Y. Desmulliez and J. Marques-Hueso, Nanoscale Adv., 2023, 5, 2280 DOI: 10.1039/D3NA00120B

This article is licensed under a Creative Commons Attribution 3.0 Unported Licence. You can use material from this article in other publications without requesting further permissions from the RSC, provided that the correct acknowledgement is given.

Read more about how to correctly acknowledge RSC content.

Social activity

Spotlight

Advertisements