Issue 12, 2018, Issue in Progress

Self-powered SBD solar-blind photodetector fabricated on the single crystal of β-Ga2O3

Abstract

A Schottky barrier diode (SBD) solar-blind photodetector was fabricated based on the single crystal β-Ga2O3. Cu and Ti/Au were deposited on the top and bottom surface of Ga2O3 as Schottky and ohmic contacts, respectively. The SBD exhibits a higher rectification ratio of up to 5 × 107 at ±2 V. The photoresponse spectra show a maximum responsivity at 241 nm and a cutoff wavelength of 256 nm. The solar-blind/ultraviolet and solar-blind/visible rejection ratio can reach a high level of up to 200 and 1000, respectively. It is interesting that the device has a clear response to the solar-blind wavelength at zero bias, which confirms it can be used as a self-powered solar-blind photodetector.

Graphical abstract: Self-powered SBD solar-blind photodetector fabricated on the single crystal of β-Ga2O3

Article information

Article type
Paper
Submitted
18 Jan 2018
Accepted
02 Feb 2018
First published
08 Feb 2018
This article is Open Access
Creative Commons BY-NC license

RSC Adv., 2018,8, 6341-6345

Self-powered SBD solar-blind photodetector fabricated on the single crystal of β-Ga2O3

C. Yang, H. Liang, Z. Zhang, X. Xia, P. Tao, Y. Chen, H. Zhang, R. Shen, Y. Luo and G. Du, RSC Adv., 2018, 8, 6341 DOI: 10.1039/C8RA00523K

This article is licensed under a Creative Commons Attribution-NonCommercial 3.0 Unported Licence. You can use material from this article in other publications, without requesting further permission from the RSC, provided that the correct acknowledgement is given and it is not used for commercial purposes.

To request permission to reproduce material from this article in a commercial publication, please go to the Copyright Clearance Center request page.

If you are an author contributing to an RSC publication, you do not need to request permission provided correct acknowledgement is given.

If you are the author of this article, you do not need to request permission to reproduce figures and diagrams provided correct acknowledgement is given. If you want to reproduce the whole article in a third-party commercial publication (excluding your thesis/dissertation for which permission is not required) please go to the Copyright Clearance Center request page.

Read more about how to correctly acknowledge RSC content.

Social activity

Spotlight

Advertisements