Issue 16, 2013

On the effect of cooling rate during melt spinning of FINEMET ribbons

Abstract

The effect of quenching wheel speed on the structure and Curie temperature of Fe73.5Si13.5B9Nb3Cu1 alloy has been investigated using X-ray diffraction, differential scanning calorimetry, transition electron microscopy and a SQUID magnetometer. Ribbons were melt-spun at different wheel speeds and then were annealed to nucleate nano crystals embedded in the amorphous matrix. The results indicated that the thickness of the ribbons was inversely proportional to the wheel speed following the power law of the type tVs−1.231. DSC and XRD results showed that at higher wheel speeds the greater potential energy triggers the formation of Fe (Si) crystallites and thus, increases the crystallinity. TEM observations confirmed the presence of an α-Fe (Si) phase with ∼11 nm crystallite size in the amorphous matrix of annealed ribbons. Special emphasis was placed on the effect of the quenching wheel speed on the Curie temperature during the measurements. To this end, the magnetization variations versus temperature were studied before and after annealing. It was found that increasing the wheel speed results in the reduction of the Curie temperature in as-spun ribbons. Moreover, the Curie temperature of the intergranular amorphous region in the annealed ribbons was at least 80 °C higher than that of corresponding amorphous phase in as-spun ribbons due to exchange interaction penetration of the adjacent Fe (Si) crystallites and relaxation processes.

Graphical abstract: On the effect of cooling rate during melt spinning of FINEMET ribbons

Supplementary files

Article information

Article type
Paper
Submitted
10 Mar 2013
Accepted
10 May 2013
First published
15 May 2013

Nanoscale, 2013,5, 7520-7527

On the effect of cooling rate during melt spinning of FINEMET ribbons

T. Gheiratmand, H. R. M. Hosseini, P. Davami, F. Ostadhossein, M. Song and M. Gjoka, Nanoscale, 2013, 5, 7520 DOI: 10.1039/C3NR01213A

To request permission to reproduce material from this article, please go to the Copyright Clearance Center request page.

If you are an author contributing to an RSC publication, you do not need to request permission provided correct acknowledgement is given.

If you are the author of this article, you do not need to request permission to reproduce figures and diagrams provided correct acknowledgement is given. If you want to reproduce the whole article in a third-party publication (excluding your thesis/dissertation for which permission is not required) please go to the Copyright Clearance Center request page.

Read more about how to correctly acknowledge RSC content.

Social activity

Spotlight

Advertisements