Development of a highly sensitive monoclonal antibody based ELISA for detection of benzo[a]pyrene in potable water

Abstract

In Europe, a limit value of 10 ng L⁻¹ was set by the European Commission for benzo[a]pyrene (B[a]P) in water intended for human consumption (Council Directive 98/83/EC) and, therefore, sensitive and reliable methods are needed to evaluate its presence. We report here on the development of a highly sensitive indirect competitive ELISA for the detection of B[a]P in potable water. Fourteen monoclonal antibodies were generated in mice using novel B[a]P derivatives. The immunoassay with the least interference and the best sensitivity was optimized and characterized. As co-solvent, ten percent methanol (v/v) was determined as the optimum concentration for B[a]P solubilization for use with the developed ELISA. With the purified antibody (clone 22F12) the average IC₅₀ for B[a]P and corresponding detection limit at a signal ∶ noise (S/N) ratio of 3 was 65 ng L⁻¹ and 24 ng L⁻¹, respectively. From the 16 EPA-designated PAHs, only chrysene, indeno[1,2,3-cd]pyrene, and benzo[b]fluoranthene showed a cross-reactivity (CR) higher than 20%. No CR was observed for two- and three-ringed aromatics as well as dibenz[ah]anthracene and benzo[ghi]perylene. The effect of pH value (range 6.5–9.5), ionic strength (specific electric conductivity 1 µS cm⁻¹–2.5 mS cm⁻¹), and inorganic ions (sodium, copper, iron, aluminium, manganese, chloride, sulfate, nitrate, and nitrite at maximum permissible levels according to the Council Directive) on both signal and sensitivity of the ELISA was studied. No significant influence of these parameters on the ELISA competition curve was found. We suggest that the optimized ELISA can be used to monitor potable water samples without previous extraction from the samples. The assay should facilitate the cleanup of B[a]P contaminated sites where B[a]P levels fall close to the limit value of the new drinking water directive.