Issue 11, 2003

Flame atomic absorption spectrometric determination of silver ion after preconcentration on octadecyl silica membrane disk modified with bis[5-((4-nitrophenyl)azosalicylaldehyde)] as a new Schiff baseligand

Abstract

A new Schiff base ligand, bis[5-((4-nitrophenyl)azosalicylaldehyde)] (BNAS), was synthesized and a highly sensitive, selective and rapid method for the determination of silver ion was developed. It is based on the rapid extraction of silver(I) ion with BNAS adsorbed on octadecylsilica (C18) membrane disk. The retained silver ion can be eluted from the disk with a minimal amount of thiosulfate solution and the silver determined with FAAS. Extraction efficiency and the influence of flow rates, type and smallest amount of stripping reagent and pH were investigated. The relative standard deviation for ten replicate extractions of silver from 1 L samples containing 2.5 µg of silver is 1.1%. The breakthrough volume for 2.5 µg of silver is 2500 mL. The effects of various cationic interferences on percent recovery of silver were studied. The re-use of a modified disk was tested and it was found that the use of the same disk modified with 7 mg of BNAS for at least ten times resulted in no change in the recovery of silver ion. The proposed method permitted large enrichment factors of about 160 and higher. The limit of detection of the proposed method is 10 ng L−1 and the method is applied to the recovery of Ag+ from different water samples and radiology film.

Article information

Article type
Technical Note
Submitted
14 Jul 2003
Accepted
03 Sep 2003
First published
06 Oct 2003

J. Anal. At. Spectrom., 2003,18, 1407-1410

Flame atomic absorption spectrometric determination of silver ion after preconcentration on octadecyl silica membrane disk modified with bis[5-((4-nitrophenyl)azosalicylaldehyde)] as a new Schiff base ligand

T. Shamspur, M. H. Mashhadizadeh and I. Sheikhshoaie, J. Anal. At. Spectrom., 2003, 18, 1407 DOI: 10.1039/B308002A

To request permission to reproduce material from this article, please go to the Copyright Clearance Center request page.

If you are an author contributing to an RSC publication, you do not need to request permission provided correct acknowledgement is given.

If you are the author of this article, you do not need to request permission to reproduce figures and diagrams provided correct acknowledgement is given. If you want to reproduce the whole article in a third-party publication (excluding your thesis/dissertation for which permission is not required) please go to the Copyright Clearance Center request page.

Read more about how to correctly acknowledge RSC content.

Social activity

Spotlight

Advertisements