Issue 20, 1994

Characterization of the intermediates formed in the reaction of Al atoms with H2O, H2S and H2Se by EPR spectroscopy

Abstract

Ground-state Al atoms have been reacted with H2O, D2O, H2S, D2S and H2Se in an adamantane matrix in a rotating cryostat at 77 K. EPR spectra demonstrate that Al atoms are inserted into these Group 16 hydrides and deuterides to give the thermally unstable species, HAlOH, DAlOD, HAlSH, DAlSD and HAlSeH. These species have large almost isotropic Al and H hyperfine interactions (hfi) of 911–984 and 134–286 MHz, respectively, and g factors of ca. 1.999. In addition, HAlSH and HAlSeH have a small H hfi of 14 and 20 MHz, respectively. Theoretical calculations show that these novel aluminium complexes have bent geometries with most of the unpaired spin located on the HAl function. While the reactions with H2O and D2O form primarily the insertion product, H2S and H2Se also produce a number of mononuclear aluminium species tentatively assigned to Al(XH)2 and Al(XH)2(H2X)n, where X = S or Se and n= 1 or 2. The Al hfi for these complexes range from 830 to 1218 MHz. Finally, in the case of the reaction of Al atoms with H2S, the tight ion pair Al+HSSH, with the parameters aAl= 21 MHz and aH(2)= 21 MHz, is generated. The results obtained from the Al atom–D2S reaction support this assignment. No evidence has been obtained for the reaction of ground-state Ga atoms with H2O to give HGaOH. H2S, on the other hand, gives Ga+HSSH and there is tentative evidence for the formation of HGaSH and Ga(H2S)4.

Article information

Article type
Paper

J. Chem. Soc., Faraday Trans., 1994,90, 3145-3151

Characterization of the intermediates formed in the reaction of Al atoms with H2O, H2S and H2Se by EPR spectroscopy

H. A. Joly, J. A. Howard, M. Tomietto and J. S. Tse, J. Chem. Soc., Faraday Trans., 1994, 90, 3145 DOI: 10.1039/FT9949003145

To request permission to reproduce material from this article, please go to the Copyright Clearance Center request page.

If you are an author contributing to an RSC publication, you do not need to request permission provided correct acknowledgement is given.

If you are the author of this article, you do not need to request permission to reproduce figures and diagrams provided correct acknowledgement is given. If you want to reproduce the whole article in a third-party publication (excluding your thesis/dissertation for which permission is not required) please go to the Copyright Clearance Center request page.

Read more about how to correctly acknowledge RSC content.

Spotlight

Advertisements