Issue 1, 1986

Activity and selectivity in catalytic reactions of buta-1,3-diene and but-1-ene on supported vanadium oxides

Abstract

The activity and selectivity in the oxidation of buta-1,3-diene, and oxidation and isomerization of but-1-ene on unsupported and supported V2O5 catalysts have been investigated in terms of the catalyst structure. The rate of oxidation is mainly determined by the number of surface V[double bond, length as m-dash]O species on the catalyst for both buta-1,3-diene and but-1-ene. The roughness of the V2O5 surface affected the activity for buta-1,3-diene, but not for but-1-ene oxidation. It was also found that TiO2 support increases the activity of the surface V[double bond, length as m-dash]O for but-1-ene oxidation. The selectivity to maleic anhydride was determined by the number of V2O5 layers on the support for both reactions. When the number of V2O5 layers was 1 or 2, the selectivity was low, while it increased markedly with an increase in the number of V2O5 layers to 5, and attained a constant value above 5 layers. Both V2O5 and support were active for the isomerization of but-1-ene to cis- and trans-but-2-ene. On V2O5, the cis/trans ratio was low, while it was as high as 3 for the Al2O3 support. The rate and selectivity of the isomerization on supported catalysts were explained in terms of the structure of V2O5 on the support. Difference in the structure–activity/selectivity correlation between oxidation and isomerization and that between but-1-ene oxidation and buta-1,3-diene oxidation were also discussed.

Article information

Article type
Paper

J. Chem. Soc., Faraday Trans. 1, 1986,82, 13-34

Activity and selectivity in catalytic reactions of buta-1,3-diene and but-1-ene on supported vanadium oxides

K. Mori, A. Miyamoto and Y. Murakami, J. Chem. Soc., Faraday Trans. 1, 1986, 82, 13 DOI: 10.1039/F19868200013

To request permission to reproduce material from this article, please go to the Copyright Clearance Center request page.

If you are an author contributing to an RSC publication, you do not need to request permission provided correct acknowledgement is given.

If you are the author of this article, you do not need to request permission to reproduce figures and diagrams provided correct acknowledgement is given. If you want to reproduce the whole article in a third-party publication (excluding your thesis/dissertation for which permission is not required) please go to the Copyright Clearance Center request page.

Read more about how to correctly acknowledge RSC content.

Spotlight

Advertisements