Issue 23, 2018

Two-dimensional porous cuprous oxide nanoplatelets derived from metal–organic frameworks (MOFs) for efficient photocatalytic dye degradation under visible light

Abstract

Bottom-up synthesis is a promising method to design and control the morphology of metal–organic frameworks (MOFs). Here, square shaped two-dimensional (2D) MOF nanoplatelets with a thickness of ∼80 nm and a lateral dimension of 4–6 μm were successfully synthesized through a facile solvothermal treatment of Cu(NO3)2 and 4,4′-bipyridine in the presence of polyvinyl pyrrolidone (PVP). The growth of a cross-weaved structure assembled via 1D chains linked with 4,4′-bipyridine along the layer stacking direction was hindered by PVP, resulting in a high-aspect ratio of the nanoplatelets. Subsequent annealing treatment converted the Cu-based MOFs into porous N-doped Cu2O/carbon composites, retaining the 2D square morphology. This annealed product showed a higher performance in the degradation of methyl orange under visible light compared to previously reported Cu2O composites. By using a small amount of the catalyst, the degradation rate could reach up to 2.5 mg min−1 gcat−1 as a result of the efficient absorption of visible light and high surface area of the porous catalysts.

Graphical abstract: Two-dimensional porous cuprous oxide nanoplatelets derived from metal–organic frameworks (MOFs) for efficient photocatalytic dye degradation under visible light

Supplementary files

Article information

Article type
Paper
Submitted
23 Mrz 2018
Accepted
01 Mai 2018
First published
01 Mai 2018

Dalton Trans., 2018,47, 7694-7700

Two-dimensional porous cuprous oxide nanoplatelets derived from metal–organic frameworks (MOFs) for efficient photocatalytic dye degradation under visible light

Y. Lin, H. Wan, F. Chen, X. Liu, R. Ma and T. Sasaki, Dalton Trans., 2018, 47, 7694 DOI: 10.1039/C8DT01117F

To request permission to reproduce material from this article, please go to the Copyright Clearance Center request page.

If you are an author contributing to an RSC publication, you do not need to request permission provided correct acknowledgement is given.

If you are the author of this article, you do not need to request permission to reproduce figures and diagrams provided correct acknowledgement is given. If you want to reproduce the whole article in a third-party publication (excluding your thesis/dissertation for which permission is not required) please go to the Copyright Clearance Center request page.

Read more about how to correctly acknowledge RSC content.

Social activity

Spotlight

Advertisements